Haim 3369 Aimable Recessed Headboard Lamp Instruction Manual
- June 13, 2024
- Haim
Table of Contents
Haim 3369 Aimable Recessed Headboard Lamp
Product Information and Warnings
IMPORTANT
- Always disconnect the power before installing, cleaning, or other maintenance.
- Please read all included assembly instructions and warnings carefully before installation. Contact Customer Service if you have any questions or concerns. Before installation, please confirm that the fixture is compatible with your supply voltage and dimming system, if present.
- LEDs are highly sensitive electronic devices, and must be treated with care. Do not open any factory sealed compartments, and avoid touching the LEDs with your hands or any object.
- Although all our fixtures are equipped with protective devices, LED electronic systems are vulnerable to power surges and supply variations. Do not install LED fixtures on the same circuit as any motors, appliances, or HVAC systems.
- Do not remove or bypass any LED Driver or Transformer that is provided with the fixture, and do not replace or substitute with another power supply.
- Fixtures must be wired in parallel on independent leads; do not “daisy chain” multiple fixtures together or wire them in series.
- All factory-made splices and connections must remain intact. LED circuits are carefully designed and built, and improper connections may damage the fixture.
- Any mounting hardware is provided for your convenience and should be used with discretion. Always use the appropriate hardware for the mounting surface.
Instructions Deinstallation
-
Cut a 4 7/8″ x 1 1/16″ rectangular hole (A), horizontally or vertically depending on desired install orientation, into the mounting surface.
Note : Headboard must have thickness of at least 0.75″ -
Install bracket (B) into hole and secure in place using set screws (C) and provided Allen key (small).
-
Connect plug (D) to fixture (E) through the back of the bracket (B).
-
Install fixture (E) to bracket (B) using flat head screws (F) and provided Allen key (large).
-
Insert power supply plug (G) into wall outlet.
Note :
To turn on fixture, touch power switch (H).
Fixture cycles between 3 brightness settings and off with each touch.
Care Instructions
Use a clean, dry cloth when dusting.
To protect the finish, avoid any harsh abrasives or chemicals.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>