ISO OLKBLP42 High Definition Split Oak Logs User Guide

: June 13, 2024
: ISO

Table of Contents

OLKBLP42 High Definition Split Oak Logs
Burner Overview
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OLKBLP42 High
Definition Split Oak Logs
User Guide

OLKBLP42 High Definition Split Oak Logs

WARNING

Failure to position the logs in accordance with these diagrams or failure to use only logs speciﬁ cally approved with this appliance may result in property damage or personal injury.
Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since appliance may not function properly and delayed ignition may occur.
The logs are fragile and should be handled with care.

PHAZER ™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour pigments burn in during the heat-activated curing process.”

note: Log numbers are located on the bottom or back of the logs.

Burner Overview

NOTE : At no time should the logs impinge or go across the ﬂ ames.

```
1.  Remove stud C. Then place log #1 ﬂ at in front of the media barrier on studs A and B.  
```
note: For ease of installation, place some of the lava rock/ charcoal (supplied) around the rear logs, covering the media tray (not illustrated). Ensure the lava rock does not cover the burner and air intake areas.
Place log #3 on the left side of the media tray.
Place the small end on log #1 and the opposite end on the left front side of the media tray.
Place log #5 on the front left side of the media tray with the charred end facing outwards.
Place log #4 on the front right side of the media tray with the charred end facing outwards.

note: Place any remaining lava rock/charcoal (supplied) around the logs, covering the media tray (not illustrated).
Ensure the lava rock does not cover the burner and air intake areas.

note: When burning, a good indicator that logs are installed correctly is that each ﬂ ame stands reasonably straight. If a log splits a ﬂ ame or drastically changes the direction of a ﬂ ame, review instructions again and/or pivot log out of direct contact.

W415-3063 / 01.28.22
Wolf Steel Ltd., 24 Napoleon Rd.,
Barrie, ON L4M 0G8 Canada
• 1(866)820-8686
www.napoleon.com