eufy 927826 SoloCam S220 Solar User Guide

eufy 927826 SoloCam S220 Solar User Guide

PRODUCT OVERVIEW

1. Solar Panel
2. Photosensitive Sensor
3. Microphone
4. Camera Lens
5. LED Indicator
6. Motion Sensor
7. Speaker
8. SYNC Button
9. USB-C Charging Port
10. Mounting Hole

SAFETY

The recommended temperature range for devices and accessories is -20°C to 50°C (-4°F – 122°F).
Unless specifically indicated that it is safe to do so in the user guide or instruction manual, do not use this device in an environment that exceeds the recommended low or high temperature.
Unless specifically indicated that it is safe to do so in the user guide or instruction manual, avoid exposing your device to direct sunshine or excessively wet environments.
It is recommended to supply the device in an environment with a temperature that ranges from 5°C ~ 25°C.
When supplying, please place the device in an environment that has a normal room temperature and good ventilation.

CAUTION!
THERE IS A RISK OF EXPLOSION IF AN INCORRECT BATTERY TYPE IS USED.
DISPOSE OF USED BATTERIES ACCORDING TO THEIR INSTRUCTIONS. CHARGING SOLOCAM

Warning:

• Replacing a battery with an incorrect type may bypass safeguards and create danger;
• Disposal of a battery in a fire or other source of significant heat, or by crushing, or cutting, may result in an explosion as well as leakage of flammable liquids and gases;
• Leaving a battery in an extremely hot environment may result in an explosion as well as leakage of flammable liquids and gases;
• A battery subjected to extremely low air pressure may result in an explosion as well as leakage of flammable liquids and gases.

LED Indicator

SETTING UP SOLOCAM

Download the App and Set Up the Device

1. Download and install the c, and sign up for an account.
   
   
   

2. Follow the on-screen instructions to add your SoloCam.

MOUNTING SOLOCAM

Select a Location
S220 SoloCam can be mounted on a wall. Select a location where it achieves the desired view. We recommend mounting it 7-10 ft (2-3 m) above ground level.

To maximize the solar panel efficiency, select a location where S220 SoloCam receives plenty of sunlight.

Mount S220 SoloCam
S220 SoloCam can be mounted both indoors and outdoors.

1. Loosen the cover of the mount by turning it counterclockwise and disassemble the mount.
   

2. This step applies if mounting onto hard surfaces such as brick or concrete. For soft surfaces such as wood, skip this step.
   Drill holes with a 15/64 in (6 mm) drill bit, then insert the anchors into the holes
   

3. Firmly screw the base of the mount onto the wall. Reassemble the mount.
   

4. Screw SoloCam onto the mount. Ensure the solar panel is facing the sky. Position SoloCam to achieve the desired view, checking it using the live stream in the eufy Security app.
   

For troubleshooting, check the Help section in the eufy Security app.

NOTICE

Declaration of Conformity

This product complies with the radio interference requirements of the European Community.

This product complies with the radio interference requirements of the European Community.

Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the Web site: https://uk.eufylife.com/.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance between the device and human body.
Wi-Fi Operating Frequency Range: 2412~2472MHz;
Wi-Fi Max Output Power:19.65 dBm
The following importer is the responsible party (contact for EU matters only)
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich, Germany

This product complies with the radio interference requirements of the United Kingdom

Hereby, Anker Innovations Limited declares that this product is in compliance with Radio Equipment Regulations 2017(SI2017/1206). The full text of the UK declaration of conformity is available at the following internet address: https://uk.eufylife.com.
Anker Technology (UK) Limited I GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdo

Your product is designed and manufactured with high-quality materials and components, which can be recycled and reused.

This symbol means the product must not be discarded as household waste and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling help protect natural resources, human health, and the environment.
For more information on the disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product

CUSTOMER SERVICE

12-month limited warranty

(US) +1 800-988-7973
(UK) +44 (0) 1604 936200
(DE) +49 (0) 69 9579 7960
( 中国 ) +86 400 0550 036
( 日本 ) 03 4455 7823
(AU) +61 3 8331 4800
(Egypt) +20 8000000826
(UAE) +971 8000320817
(Kuwait) +965 22069086
(Saudi Arabia) +966 8008500030
(Middle East & Africa) +971 42428633

support@eufylife.com

Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

References

• eufy | Built with Care | Up to 53% Off | eufy UK
• eufy | Built with Care | Up to 53% Off | eufy UK

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>