AURATON SMART Floor Heating Controller User Manual
- June 13, 2024
- AURATON
Table of Contents
AURATON SMART Floor Heating Controller
Description
Description of the device, the push buttons, and the indicator lights
- LED indicating the status of the power supply
- LED indicating the status of operation of the pump or the central heating furnace
- Button (Del) for evaporating controllers or returning to factory settings
- Button (Link) for pairing with the AURATON Pulse control unit
- Button (Test) with indicator of the tester function mode
- 230 V AC power connection
- Network switch
- NC, COM, NO, potential-free contacts of the transmitter
- Control of the central heating pump
- Terminals of heating zones 1-8 (actuators)
- Heating zone buttons 1-8
- LEDs indicating operation of zones 1-8
- Connection for an external temperature sensor
- Antenna
DIN rail mounting
- DIN rail
- Hook the AURATON Floor Heating Controller onto the DIN rail with the upper hooks.
- Pull the lower hook down with a „flat” screwdriver.
- Put AURATON Floor Heating Controller in the right place.
- Release the lower hook.
SMART wireless control strip for underfloor heating
The AURATON Floor Heating Controller is SMART, 8-zone, wireless underfloor
heating control strip, designed to work with AURATON Vela actuators, a central
heating pump and a heating device.
WARNING! All connections should be made when power source is
disconnected.
WARNING! AURATON Floor Heating Controller is designed for mounting on a
DIN-rail in the installation cabinets. Metal cabinets should not be used due
to hindered radio communication.
Signaling the operation of AURATON Floor Heating Controller:
Signaling in normal state:
Signaling in the TEST state:
ATTENTION: For easy installation, the terminals are equipped with
removable clamps. Before cable connections are made, they can be disconnected
from AURATON Floor Heating Controller.
WARNING: All connections should be made when power source is
disconnected.
- Only one AURATON wireless controller can be paired to a given zone.
Connection
Connection of the central heating furnace
The central heating furnace must be connected to the COM–NO or COM-NC clamps.
This is a standard one-pole bistate transmitter. In most cases, the NC clamp
is not used.
- Actuators
- Central heating pump
- Heating device e.g. gas boiler
- External temperature sensor
Connecting more actuators to one zone
- Actuators (max 6 per 1 zone)
Pairing the AURATON Floor Heating Controller with the AURATON Heat Monitor
Pairing the AURATON Floor Heating Controller with the AURATON Pulse
Technical data
Disposing of the devices
The device is marked with a symbol of a crossed waste bin. Pursuant to
European Directive 2012/19/EU and to the Act on waste electrical and
electronic equipment, such mark indicates that the device, at the end of its
service life, must not be disposed of together with other household waste. The
user is responsible for delivering the devices to a reception point for used-
up electric and electronic equipment. Hereby, LARS Andrzej Szymanski declares
that the radio equipment type AURATON Floor Heating Controller is in
compliance with Directive 2014/53/EU and 2011/65/EU. The full text of the EU
declaration of conformity is available at the following internet address:
https://manuals.auraton.pl
Manufacturer
LARS Andrzej Szymański, Świerkowa 14,
64-320 Niepruszewo, POLAND
www.auraton.pl
References
- AURATON pompy ciepła, termostaty, sterowniki, smart home
- AURATON manuals – Instrukcje urządzeń AURATON
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>