TURTLE BEACH US QSG 071417 WEB Ear Force Recon Camo Gaming Headset User Guide
- June 13, 2024
- TURTLE BEACH
Table of Contents
RECON CAMO
QUICK START GUIDE
IMPORTANT READ BEFORE USING
Package Contents
In-Line Controls
PS4™ Setup
- Go to Settings >> Devices >> Audio Devices
a. Set Input & Output Device to Headset Connected to Controller
b. Set Output to Headphones to All Audio
c. Set Volume Control [Headphones| level to maximum
d. Select Adjust Microphone Level and follow the on-screen instructions off calibrate your microphone
Note
The Recon Camo requires the Xbox One Controller with 3.5mm headset jack. Purchase the Ear Force Headset ‘Audio Controller from turtiebeach.com for use with the original Xbox One Controller.
Xbox One Setup
VOLUME SETUP
- 0n the home screen, navigate to the If tide of the screen and down to the Settings “Gear™
- Sot Headset Volume to maximum
b. Set Headset chat Mixer to your preferred Game/ Chat Balance
c. Set Mic Monitoring to your preferred level
SURROUND SOUND SETUP [AVAILABLE ONLY ON XBOX ONE]
- Go to Settings » Audio Devices » Audio Output
- Set Headset Format to Windows Sonic for Headphones
For more information on Xbox Surround Sound visit: turtlebeach.com/sonic
PC/Mac & Mobile Setup
Note: If your PC uses separate Green/Pink connectors for audio you will
need a PC Splitter Cable. This adapter is available online at
turtlebeach.com
Regulatory Compliance Statements for the EAR FORCE Recon Camo
Federal Communications Commission (FCC) Compliance Notices
Class B Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15, Subpart B of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: LI 1 This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Canadian ICES
Statements Canadian Department of Communications Radio Interference
Regulations This digital apparatus does not exceed the Class B limits for
radio-noise emissions from a digital apparatus as set out in the Radio
Interference Regulations of the Canadian Department of Communications. This
Class B digital apparatus complies with Canadian ICES-003.
European Union and European Fair Trade Association (EFTA) Regulatory
Compliance
Declaration of Conformity
Marking by this symbol: indicates compliance with the Essential Requirements
of the EMC Directive of the European Union (2014/30/EU).
This equipment meets the following conformance standards:
Safety:
EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12: 2011 + A2: 2014
(T-Mark License],
IEC 60950-1: 2005 (2nd Ed.) + Am 1: 2009 + Am 2: 2013
(CB Scheme Certificate),
EN 50332-1: 2000, EN 50332-2: 2003, EN 71-3: 2013
Also Licensed for Standards:
UL 60950-1: 2007 R10.14,
CAN/CSA-C22.2 No. 60950-1-07 + A1: 2011 + A2: 2014
Additional licenses issued for specific countries available on request
Emissions:
EN 55022: 2010 + AC: 2011, CISPR 22: 2008| Immunity:
EN 55024: 2010, CISPR 24: 2010
EN 61000-4-2: 2009, EN 61000-4-3: 2006 + A1: 2008 + A2: 2010,
EN 61000-4-8: 2010
The products are licensed, as required, for additional country specific
standards for the International Marketplace. Additional issued licenses
available upon request.
Environmental:
Low Voltage Directive 2014/35/EU, RoHS 2011/65/EU,
REACH 2006/1907/EC, WEEE 2012/19/EU, Packaging 94/62/EC,
Toys Safety Directive 2009/48/EC
---|---
**** This symbol on the product or its packaging indicates that this product
must not be disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by
handing it over to a designated collection point for the recycling of waste
electrical and electronic equipment. The separate collection and recycling of
your waste equipment at the time of
disposal will help conserve natural resources and ensure that it is recycled
in a manner that protects human health and the environment. For more
information about where you can drop off your waste for recycling, please
contact your local authority, or where you purchased your product.
Please visit the following URL for a complete copy of the declaration of
conformity: http://www.turtlebeach.com/homologation
This product is compliant with the Consumer Product Safety Improvement Act of
2008, Public Law 110-314 (CPSIA]