AURATON 673 11407995087 Radiator Controller Owner’s Manual

AURATON 673 11407995087 Radiator Controller

The extended instruction can be found at:https://manuals.auraton.pl

Description of the thermostatic head

Auraton Radiator Controller is a thermostatic head, which works with a wireless Auraton Heat Monitor controller. The thermostatic head is mounted directly on the radiator.

Installation of the thermostatic head

Danfoss radiator with RA-N insert
In order to mount the Auraton Radiator Controller on a radiator with Danfoss RA-N insert, proceed as follows:

1. Insert two halves of B (6) reduction onto the Danfoss insert

2. Screw tightly reduction A (7) onto the installed reduction B (6)

3.  Perform steps 5 to 11 described in section‚ Radiator with M30x1.5” insert’
   ‚Radiator with M30x1.5” insert
   To mount the Auraton Heat Monitor thermostatic head on a radiator with the most popular insert on the market (M30x1.5) proceed as follows:

4. Screw tightly reduction A (1) onto the insert. The reduction is provided as a set with the thermostatic head.

5. Remove the battery cover (2) of the head using a flat-head screwdriver.

6. Install two AAA batteries in the thermostatic head, paying attention to their polarity. The spindle of the thermostatic head moves to the extreme open position, which is necessary to mount the head on the reduction.

7. Turn the securing ring (3) into the „unlocked” position.

8. Slide the thermostatic head (4) on the reduction A (5) fully.

9. Turn the securing ring (3) into a „locked” position.

10. Perform the pairing procedure with Auraton Heat Monitor, if not performed earlier.

11. Close the battery cover (2) of the thermostatic head.

Pairing devices

1. Press the black battery cover close button on the electronics board 3 times (quickly).
2. If the first pairing fails, reset the device to it’s factory default settings, move the devices closer together and pair them again. Find out how to restore factory settings at: https://manuals.auraton.pl

Technical specifications

• Working temperature range: 0 – 45°C
• Temperature measurement range: 0 – 45°C
• Temperature control range: 0 – 40°C
• Temperature setting accuracy: 0,1°C
• Temperature measurement accuracy: 0,1°C
• Default temperature setting: 21°C
• Additional function: FrostGuard
• Working mode control: LED, sound signal
• Power supply: 2 x LR03 (AAA)
• Compatible with Internet getaway: Auraton Pulse
• Level of security: IP20
  • Radiofrequency:
  • 868.150 MHz
  • 868.450 MHz
  • 869.800 MHz
• Radio signal strength: 11 dBm
• Radio receiver category: 2
• Operation range: in a building – up to 30 m

Disposing of the devices

The devices are marked with the crossed waste bin symbol. According to European Directive no. 2012/19/EU and the Act concerning used-up electric and electronic equipment, such a marking indicates that this equipment may not be placed with other household-generated waste. The user is responsible for delivering the devices to a reception point for used-up electric and electronic equipment. Hereby, LARS Andrzej Szymański declares that the radio equipment type Auraton Radiator Controller is in compliance with Directive 2014/53/EU and 2011/65/EU. The full text of the EU declaration of Conformity is available at the following internet address: https://manuals.auraton.pl

References

• AURATON manuals – Instrukcje urządzeń AURATON

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>