ZEPHYR 56240027 Set of 4 Presrv Casters Installation Guide
- June 13, 2024
- ZEPHYR
Table of Contents
WWW.ZEPHYRONLINE.COM
Installation Guide
PRCAST-C001
Presrv™ Casters, Set of 4
56240027 Set of 4 Presrv Casters
56240027
Spacer, PRCAST-C001, Set of 4
Only for kegerator models PRKB24C01AG and PRKB24C01AS-OD beginning with serial
number 10.
This caster wheel installation guide is only applicable for the following
models: PRB24C01AS-OD, PRKB24C01AG, PRKB24C01AS-OD, and PRR24C01AS-OD.
In order to install the caster wheels onto the kegerator models, PRKB24C01AG
and PRKB24C01AS-OD, both PRCAST-C001 and its spacers, 56240027, are required.
To convert the stationary unit into a moble unit, please follow the
instructions below. Installing the caster wheel accessory should require at
least two people to prevent injury.
-
Empty all contents within the cooler and close the door afterwards. Lay the cooler gently down on its right side.
-
Remove the leveling legs from the cooler by twisting the leveling legs counterclockwise. Perform this step for each leveling leg.
-
Place and align the spacers over the screw hole openings underneath the kegerator, making sure the larger opening of the spacer is over the compressor bolt.
NOTE : Only install the spacers if the compressor bolt interferes with the caster installation. If a spacer is used, make sure to use one for each caster; otherwise, the cooler will unevenly stand. -
Install each caster wheel by aligning it with the spacer and securing it with (4) M5*12 screws and washers. Perform this step for each corner.
-
Set the cooler back to its upright position. Place all contents back into the cooler.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>