siku 67XX Series RC Tractors Instruction Manual

June 13, 2024
siku

siku 67XX Series RC Tractors

siku -67XX -Series -RC -Tractors -product image

Product Information

The product is a front loader that can be used for raising and lowering various attachments, such as forks and shovels. It is compatible with SIKUCONTROL sets 3658, 3661, and 7070. The product also includes a control system for operating the front loader.

Product Usage Instructions

Raising and Lowering Front Loader:

  1. Use the lever or control system to raise and lower the front loader.

siku -67XX -Series -RC -Tractors -fig \(1\)

Using Forks:

  1. Attach the forks to the front loader.
  2. Use the lever or control system to load pallets and guide the forks in a parallel motion.

Raising and Lowering Shovel:

siku -67XX -Series -RC -Tractors -fig \(10\)

  1. Attach the shovel to the front loader.
  2. Use the lever or control system to raise and lower the shovel.

Blinking Mode:

  1. Use the control system to activate the flashing mode.

CAUTION: Any changes or modifications not approved by the manufacturer may void the user’s authority to operate this device. This device complies with FCC rules and should not cause harmful interference. If interference occurs, try reorienting or relocating the receiving antenna, increasing separation between equipment and receiver, or consult a professional for assistance. To comply with RF exposure guidelines, keep the product at least 20 cm away from nearby persons.
For more information, visit http://www.siku.de/de/downloads.html.

Inserting the batteries

siku -67XX -Series -RC -Tractors -fig \(7\)

siku -67XX -Series -RC -Tractors -fig \(9\)

System start

siku -67XX -Series -RC -Tractors -fig \(11\)

siku -67XX -Series -RC -Tractors -fig \(12\)

System start

siku -67XX -Series -RC -Tractors -fig \(13\)

siku -67XX -Series -RC -Tractors -fig \(14\)

 Control

siku -67XX -Series -RC -Tractors -fig \(15\)

siku -67XX -Series -RC -Tractors -fig \(16\)

Lights

siku -67XX -Series -RC -Tractors -fig \(17\)

siku -67XX -Series -RC -Tractors -fig \(18\)

Flashing

siku -67XX -Series -RC -Tractors -fig \(19\)

Automatic coupling

siku -67XX -Series -RC -Tractors -fig \(20\)

Mounting front loader accessories

siku -67XX -Series -RC -Tractors -fig \(2\)

Loading a pallet and parallel motion of the fork

siku -67XX -Series -RC -Tractors -fig \(4\)

Steering adjustment

siku -67XX -Series -RC -Tractors -fig \(5\)

Assign your own model name

siku -67XX -Series -RC -Tractors -fig \(6\)

CAUTION: Changes or Modifications not expressly approved by the party responsible could void the user’s authority to operate this device.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with the RF exposure guidelines, place the product at least 20 cm from nearby persons.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals