CAMDEN DOOR CONTROLS RX-DB Lazer Point Installation Guide

June 13, 2024
CAMDEN DOOR CONTROLS

CAMDEN DOOR CONTROLS logo Lazerpoint™ RX-DB
Installation Instructions

RX-DB Lazer Point

CAMDEN DOOR CONTROLS RX-DB Lazer Point - Ensure STEP 1
– Ensure power is turned off, or removed from board
– Carefully press in two tabs on one end of plastic case
– Pry case lid up and off circuit board. Set aside
STEP 2
– Remove daughterboard from packaging, and carefully insert it into either one of the two headers on main circuit board
– Ensure all 9 pins are properly seated into header, and daughterboard is straight up and down (not bent over)
STEP3
– Repeat for additional daughterboard, if desired
– Using case lid as a guide carefully route antenna wires to fit into slots on lid
– Re-install lid making sure wires are routed to avoid damage
– lid should snap onto tabs on ends
CAUTION !
Do not install or remove
Daughterboard(s) with unit powered.
Remove power first

Camden Door Controls
5502 Timberlea Blvd.
Mississauga, Ontario
L4W 217

SCALE: NONE| DRAWN BY: DGW| DATE: 03/24/10| REVISED: 16/09/15
RX-DB Daughterboard Assembly
DRAWING No: DRG-RX-DB| FILENAME: Daughterboard Assembly Diagram
Ver_1_01.vsd

CAMDEN DOOR CONTROLS RX-DB Lazer Point - Ensure1
CAMDEN DOOR CONTROLS logowww.camdencontrols.com
Toll Free: 1.877.226.3369
Made in Canada
File: Lazerpoint™ RX-DB Instructions.doc Rev1
Revision: 16/09/2015
Part No.: 40-82B123
5502 Timberlea Blvd.,
Mississauga, ON Canada
L4W 2T7 Certified ISO 9001: 2008

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

CAMDEN DOOR CONTROLS User Manuals

Related Manuals