Geovision 84-SR13520-0010 Dual Band RFID Reader Installation Guide
- June 13, 2024
- GeoVision
Table of Contents
Geovision 84-SR13520-0010 Dual Band RFID Reader Installation Guide
GV-SR1352 Card Reader
The content of this installation guide refers to GV-SR1352.
Introduction
GV-SR1352 is a dual-band RFID card reader that recognizes access control cards. Featured with Wiegand outputs, GV-SR1352 can be connected to any Wiegand-compatible access control systems. Its dual-band capability offers great flexibility for integrators to solve card management issues on the locations, installed with both 125 kHz EM and 13.56 MHz readers. For outdoor use, GV-SR1352 comes with a weather-sealed and IP66-compliant housing.
Specification
| Power Source | DC 9 ~ 24 V |
|---|---|
| Power Consumption | 25 mA (max) |
| RFID Frequency | 125 kHz and 13.56 MHz |
| Reading Range | 1 – 3 cm (0.3 – 2.3 in) |
| Wiegand Interface | Wiegand 26 bits for EM, 26 / 34 bits for Mifare |
| Operating Temperature | -20 °C ~ 60 °C (-4 °F ~ 140 °F) |
| Operating Humidity | 10% to 95% RH |
| Color | Black |
| Ingress Protection | IP66 |
| Dimensions (H x W x T) | 103 x 47.86 x 20 mm (4.06” x 1.89” x 0.79”) |
| Weight | 150 g (0.33 lb) |
Installation
- Drill 2 holes (A, C) on the wall for the screws and one hole for the
- Knock the plastic screw anchors to the holes (A, C).
- Fix the back cover on the wall with 2 screws.
- Thread the cable through the cable hole (B).
- Attach the unit to the back
Electric Wire
| Wire Color | Function | Notes |
|---|---|---|
| Red | Power + | + DC (9-24V DC) |
| Black | GND | Ground |
| Green | D0 | Data 0 |
| White | D1 | Data 1 |
| Brown | LED | Green LED Light Control |
| Yellow | Buzzer | Buzzer Control |
**Note:** Brown and yellow wires are optional connections.
Function ****
Read Card
| The LED light turns Green, and the buzzer beeps while the reader outputs
the Wiegand signal.
---|---
External LED Control| When the input voltage for LED is low, the LED
turns Green.
External Buzzer Control| ****
When the input voltage for Buzzer is low, the Buzzer beeps.
Wiegand Data Output
| ****
Wiegand 26/34 bits range available for the reader, EM and Mifare cards are forced to output based on the reader setting.
Data Signal
Pulse Times
Description| Reader Typical Time
Pulse Width Time| 42 µS
Pulse Interval Time| 2 mS
The above table shows the wave form of pulse width time (the duration of a pulse) and pulse interval time (the time between pulses) of the Wiegand data output from the readers. (Example 1010)
Packing List
- GV-SR1352
- Screw driver
- Screw x 2
- Plastic Screw Anchor x 2
- Installation Guide