KRISTALLUM 20230920 LED Medicine Cabinet Installation Guide
- June 13, 2024
- KRISTALLUM
Table of Contents
KRISTALLUM 20230920 LED Medicine Cabinet
Product Information: – Product Name: LED Medicine Cabinet – Model: [model number] – Dimensions: [dimensions] – Material: Aluminum Alloy Plate – Features: Touch Function, Defogging Function, LED Strip
Product Usage Instructions
1. Installation: – Gather the following hardware and tools: Power Drill – Mallet – Tape Measure – Safety Goggles – 1/4″ & 1/8″ Drill Bits – Pencil – Level – Ensure that you have all the parts and fittings before discarding any packaging. – Before starting the installation, make sure the power to the junction box is turned off. – Carefully unpack the LED cabinet and place it on a protected surface to prevent chipping of the corners. – Take caution when drilling pilot holes to avoid damaging any existing wiring or pipe work that may be concealed. – It is recommended to have a certified electrician perform the installation. The mirror must be connected to a GFI (Ground Fault Interrupter). 2.
Maintenance: – Wipe the LED medicine cabinet clean with a soft damp cloth. – Apply glass cleaner to the cloth and do not apply it directly to the mirror. – Avoid using abrasive cleaners as they may damage the finish or exposed LED strip.
3. Introduction of Touch Function: – After powering on, the button will show white and be in a waiting state. – Click the button to turn on the defogging function. The button will turn yellow. – Click the button again to turn off the defogging function. The button will return to white. Note: All dimensions and specifications provided are approximate and subject to change without notice.
HARDWARE AND TOOLS
HARDWARE LISTS
INSTALLATIONINSTRUCTIONS
APPLY TO THE BELOW STYLE OF LED MEDICINE CABINET
Please read carefully and save these instructions
Don’t discard any of the packaging until you are sure that you have all of the
parts and the fitings Make sure power to the junction box is off before
commencing installation.
IMPORTANT
- Unpack LED cabinet. DO NOT lay cabinet on tiled or concrete surface prior to installation Cabinet must be on protected surface to prevent chipping of the corners
- Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may be concealed.
- A certified electrician must perform all work.The mirror must be connected to a GFI
INSTALLATION
Please refer the installation diagram on installations manual.
- Unpack the LED medicine mirror and prepare tools needed.
- Use the tape measure the height, and draw the horizontal. Measure the distance of the hole, and mark the hole place on the wall
- Drill holes,and put in the plastic expansion bolt,then fix the aluminum bar by screws (See Pic.3&Pic.4);
- Connect hardwire to power line.Make sure the power off(Voltage:AC110-12V,50/60Hz)
- Hang the cabinet on the wall; don’t remove your hands until its safety.
- onnect the lower end of wall with the cabinet body by using the coner brace.
MAINTENANCE
Wipe clean with a soft damp cloth. Apply glass cleaner to cloth and do not apply directly to mirror Never use abrasive cleaners as these could damage the finish or exposed LEDstrip 2
INSTALLATION DIAGRAM
INTRODUCTION OF TOUCH FUNCTION
-
After power on, the button shows white and it is in waiting state,
click to turn on the defogging function and the button turn on yellow.
Click again to turn off the defogging function and the button to turn to white. -
After power on, the button shows white and it is in waiting stagte,
click to turn on the light function and the button turn on yellow.
Click again to turn off the light function and the button to turn to white.
Long click the button to make the light gradually dims
Click the button again and the light gradually brightens -
After power on, the button shows white and it is in waiting state, click to turn on the light function and the white turn on yellow.
Press to switch the color temperature of light by 3k-yellow, 4.5k-natural or 6k-cold white