SUNCO LIGHTING LOD-KFL Series LED Mini Flood Light Installation Guide
- June 13, 2024
- Sunco Lighting
Table of Contents
SUNCO LIGHTING LOD-KFL Series LED Mini Flood Light
Product Information
- Product Name: LOD-KFL Series
- Product Type: Floodlight Fixture
SAFETY INSTRUCTIONS
Read instructions carefully before attempting to install fixture
- All wiring should be performed by a qualified electrician.
- Disconnect power before installing or servicing. This fixture must be wired in accordance with the National Electrical
- Code and applicable local codes and ordinances.
- Proper grounding is required to ensure personal safety.
- This fixture is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures.
CAUTION: Risk of fire
WARNING: Make certain power is OFF before installing or maintaining the fixture. No user-serviceable parts inside.
CLEANING & MAINTENANCE
CAUTION: Be sure the fixture temperature is cool enough to touch. Do NOT clean or maintain while the fixture is energized.
- Clean glass lens with a non-abrasive glass cleaning solution.
- Do NOT open the fixture to clean the LED. Do NOT touch the LED.
Note: These instructions do not cover all details or variations in equipment, nor do they provide for every possible situation during installation, operation or maintenance.
TROUBLESHOOTING
- Check that the line voltage at the fixture is correct. Refer to wiring directions.
- Check that the fixture is grounded properly.
JUNCTION BOX MOUNTING
Mount to a weatherproof junction box and cover plate (not supplied) as shown in Fig. 1 and Fig. 2. To ensure a weatherproof seal, apply weatherproof silicone sealant to the back of the junction box. This is especially important with an uneven wall surface.
- Thread the fixture into the cover plate. Seal arm thread using Teflon tape or silicone sealant.
- Connect wires correctly.
- Attach the cover to the junction box.
- Aim the floodlight in the direction desired and tighten the locknut and arm screw.
GROUND MOUNTING
Mount to a pole as shown in Fig. 3.
- Thread fixture into pole cap.
- Connect wires correctly.
- Place post cap on the pole.
- Aim floodlight in the direction desired and tighten the locknut and arm screw.
TRUNNION MOUNTING
CAUTION: UL and C UL listed or CSA certified liquid tight cord grip suitable for use with three conductor type STW flexible cord shall be used for connection to a wet location outlet box provided by others.
To adjust the angle of the fixture using the trunnion shown in Fig. 4:
- Loosen the pivot bolts and angle locking screw.
- Adjust the fixture to the desired angle.
- Tighten pivot bolts and angle locking screw.
WIRING: Universal voltage driver permits operation at 120V through 277V, 50/60Hz except fixtures factory ordered with a (PC).
- Connect the BLACK fixture lead to the (+) LINE supply lead.
- Connect the WHITE fixture lead to the (-) COMMON supply lead
- Connect the GROUND wire from fixture to the supply ground.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>