manta5 XE-1 Fit Shoe Rear Foil Instructions
- June 13, 2024
- manta5
Table of Contents
manta5 XE-1 Fit Shoe Rear Foil Instructions
Work Instruction – Fit Shoe Assembly to Rear Foil
ID | Description | Ta s k |
---|---|---|
M4 Hex Key | Fasten M6 Countersink Head Foil Screws |
-
Support the Rear Foil with the bottom side up and position the Shoe Assembly against the flat surface, with the holes aligning and rounded end facing forward as shown below.
INFORMATION: The holes in the Rear Foil should align with that in the Shoe Assembly and must be clear of any debris or obstruction. The rounded part (leading edge) of the Rear Foil must face forward, and similarly the rounded part (with retained fixing bolt) of the Shoe Assembly must face forward. -
Apply Tef-Gel (or equivalent) lubricant to the screw threads, fit the M6 Countersink Head Screws (length 30 mm) to the Shoe Assembly through the Rear Foil.
CAUTION: To avoid damage to screw heads, do not use a Hex Drive with rounded end for tasks where access is unrestricted.
-
Fasten the screws evenly to a Torque value of 5 Nm.
-
The Rear Foil with Shoe Assembly can now be turned over with the Shoe Assembly on top. Perform one last check to ensure the Rear Foil and Shoe Assembly orientation is correct.
Watch video on how to install below:
Documents / Resources
|
manta5 XE-1 Fit Shoe Rear
Foil
[pdf] Instructions
XE-1, XE-1 Fit Shoe Rear Foil, Fit Shoe Rear Foil, Shoe Rear Foil, Rear Foil,
Foil
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>