AKG CHM99 Hanging Cardioid Condenser Microphone Quick Start Guide
- June 13, 2024
- AKG
Table of Contents
AKG CHM99 Hanging Cardioid Condenser Microphone
Quick Start Guide
Using an XLR cable, connect the microphone to the input on an audio mixer with phantom power and adjust the volume. Further information can be found overleaf.
Setting Up
Assemble the microphone with the AKG PS 3 F-Lock mounting base on a tabletop, or assemble it with the AKG SA 60 tripod connector on a floor tripod or table- top tripod. Alternatively, suspend the microphone from a suitable hook in the ceiling
Application
-
In the case of microphones with a cardioid polar pattern, most sound attenuation occurs at 180°. These microphones should therefore preferably be used where there is an interference noise source or a loudspeaker directlv opposite the speaker
-
In the case of microphones with a hypercardioid polar pattern, most sound attenuation occurs at 110°. The hypercardioid pattern produces the highest front-to-back ratio and can pick up the greatest amount of effective sound. These microphones are therefore preferred for use on floors or table tops with high levels of interference noise
-
The equivalent microphone from the 99 series can be used either on conference tables and lecterns or suspended for recording plays or choirs on a stage. To stabilize a suspended microphone, thread a fishing line through the eye on the spring clip and attach the line to two opposite walls.
Configuration
Bass Cut Configuration
Noise from the wind and rumbling noises may cause low-frequency interference noise. The microphone’s switchable bass cut filter further reduces low-end distortion. The filter slope is more than 12 dB/octave at 150 Hz and below. The bass cut also minimizes the proximity effect that may arise when close-in miking from less than 6 inches.
Volume Configuration
Adjust the input level on the audio mixer. Adjust the gain potentiometer whilst speaking into the microphone, and at the same time observe the level indicator. For best results, we recommend using the highest possible input level in order to maintain the best possible signal-to-noise ratio. However, even when someone is speaking loudly into the microphone you should take care to ensure that the level indicator never moves into the red zone; failure to ensure this can result in unpleasant-sounding distortions. Carefully increase the input level until the level indicator is just below the red zone. Once you have carried out these steps you can now use the output controller on your audio mixer to adjust the volume of your microphone.
Tips And Tricks
- Maintain a gap between the speaker’s mouth and the microphone, and do not exceed the maximum bend angle. Only bend the flexible part of the microphone.
-
The microphone is fitted with a wind guard to suppress annoying pops or whistling noises when the speaker produces a plosive (p, t).
-
This product conforms to the standards listed in the Declaration of Conformity. To order a free copy of the Declaration of Conformity, visit http://www.akg.com or contact sales@akg.com.
AKG
- www.akg.com
- AKG Acoustics GmbH Lemböckgasse 21-25, 1230 Vienna /AUSTRIA, Phone: + 43 1 86654 0
- E-mail: sales@akg.com
- For other products and distributors worldwide visit www.akg.com or www.harman.com
FAQs
What is the type of microphone is the AKG CHM99?
The AKG CHM99 is a hanging cardioid condenser microphone designed for overhead audio capture.
What is the polar pattern of this microphone?
This microphone has a cardioid polar pattern, which helps reject unwanted background noise from the sides and rear.
What is the frequency response range of the AKG CHM99?
The frequency response range of the AKG CHM99 typically spans from i65Hz to 20kHz. Sensitivity: 4 mV/Pa (-48 dBV ) Max. SPL: 140 / 145 dB SPL (for 1% / 3% THD).
Is the CHM99 suitable for studio recording?
Yes, the AKG CHM99 is suitable for studio recording, especially for capturing instruments and vocals.
Does it come with a mounting bracket or suspension system?
Yes, it usually comes with a mounting bracket or suspension system for easy installation and positioning.
What is the microphone's sensitivity rating?
The sensitivity rating of the AKG CHM99 is typically 125 dB SPL (1% THD) dB.
Can it be used for live sound applications?
Yes, the AKG CHM99 can be used for live sound applications such as concerts and conferences.
Does it require phantom power?
Yes, this microphone typically requires phantom power to operate.
What is the recommended distance from the sound source?
A typical recommended distance for optimal audio capture is 15 distance inches (or centimeters).
Is it suitable for outdoor recording?
While it can be used outdoors, it's best suited for controlled indoor environments to minimize wind and environmental noise interference.
Does it come with a warranty?
The warranty details for the AKG CHM99 may vary, so please check the product packaging or the manufacturer's website for warranty information.
What accessories are included with the microphone?
The accessories included with the AKG CHM99 may vary, but they often include a windscreen, mounting hardware, and user manual.
Can it be used for video recording or broadcasting?
Yes, the AKG CHM99 can be used for video recording, broadcasting, and other audio capture applications where a hanging cardioid microphone is suitable.
Download This PDF Link:AKG CHM99 Hanging Cardioid Condenser Microphone
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>