acson AFF10A Foldable Floor Fan User Manual

acson AFF10A Foldable Floor Fan

Product Information

• Product Model Name: Foldable Floor Fan AFF10A
• Power Supply: 220-240V, 50/60Hz
• Rated Voltage: DC12V, 1A
• Rated Power: 14 W
• Number of Blades: 9
• Speed Control: 8 levels
• Battery Capacity: 6600 mAh
• Unit Dimension (HxWxD):
  • Folded: 138 x 300 x 295 mm
  • Table Fan: 470 x 300 x 295 mm
  • Floor Fan: 900 x 300 x 295 mm
• Net Weight: 2.1 kg
• Material: ABS

Product Usage Instructions

The control panel of this fan is located at the rotating base panel. The display panel is located on the fan.

automatically run at the previous fan speed. Press again to turn
off the fan.
Fan Speed (+/-)| Press “+” or “-” to adjust the fan speed by one level. The
display panel will show the corresponding fan speed based on your
selection from 1st to 8th level.
Swing| When the fan is operating, press this button to enable the
swing function. Press again to disable the swing function.
Nature Breeze Mode| Press this button to activate Nature Breeze Mode. The LED
lights up indicating the mode is active. Press again to exit this
mode. The fan will return to its original fan speed.
Timer (+/-)| Press this button to activate the timer. Press “+” or “-” to
adjust the timer setting by 1 hour. The display panel will show the
corresponding timer setting based on your selection from 1 to 8
hours. When reaching its maximum (8 hours), press this button to
disable the timer.

WARNING: For first-time use, please pull out the battery insulation sheet attached at the back of the remote control. Please only use the default adapter for this fan.

DISCLAIMER

• In complying with the policy for continuous improvement of Acson Malaysia Sales & Service Sdn Bhd (herein after referred to as “Acson”), the information contained in this document is subjected to change without prior notice.
• While Acson makes no commitment to update or provide current information automatically to the manual owner, that information (if applicable) can be obtained by contacting the nearest Acson office, distributors or dealers network.
• It is the responsibility of the operator or service personnel to verify the applicability of these documents, then prior to working on the equipment. They should verify with the owner whether the equipment has been modified and if current literature is available.
• Any and/ or all colours depicted in the marketing materials for this product are only representation of the product and should not be taken as accurate. Whilst every effort is made to ensure product consistency, we could not be held responsible for variations between batches.

INTRODUCTION

Acson foldable floor fan helps to circulate the air of your space and provide ventilation within its proximity.

470 x 300 x 295 mm (Table Fan)

900 x 300 x 295 mm (Floor Fan)

Net Weight| 2.1 kg
Material| ABS

PRODUCT OVERVIEW

PRODUCT OVERVIEW

8 levels of airflow control powered by DC brushless motor which provide high airflow and low noise operation.

WARNING: For first time use, please pull out the battery insulation sheet attached at the back of remote control. Please only use the default adapter for this fan.

OPERATION GUIDELINE

The control panel of this fan is located at the rotating base panel.

For display panel located on the fan:

The remote control which come together with this fan serve as an option to control the fan conveniently.

For remote control:

Before operating this floor fan, please make sure the unit is placed on a flat surface.

How to setup the fan:

• The fan is in a folding state by default.
• Open the fan vertically from the head (Figure 1).
• Pull the fan head according to the direction of arrow (Figure 2).
• When the fan grille reach 180° and parallel to the telescopic rod, the rod is locked automatically by indicating a click sound (Figure 3).
• You can now start to turn on your fan.

How to operate the fan:

• Connect the fan to power supply. Disconnect it when the unit is fully charged.
• Press the On/Off button to turn on the fan.
• Press the fan speed button to adjust the airflow. Press “+” increase the airflow, while press “-” to decrease the airflow.

How to adjust the height and swing angle:

• The vertical swing angle of this fan can be adjusted manually by pulling up and down, maximum 180° (Figure 4).
• The vertical height of this fan could be adjusted by pulling up the telescopic rod or the neck (Figure 5).

How to charge the fan:

• The indicator light at the display panel will blink when it is in low battery stage. This will affect the fan speed by either lower fan speed or completely cease the operation.
• Please do not attempt to turn on the fan at low battery stage.
• The charging could not be perform when the fan is operating. You need to turn off the fan and connect to power supply to charge it.
• There is an alphabet F blinking on display panel when you charge the fan. When the battery is fully charged, the F will stop blinking.
• When the F not blinking, please turn off the power supply and unplug the adapter.

Operating Conditions

• When the fan is operating & connect with power supply (Normal Mode):
  • The internal battery is not charging and storing electrical energy.
  • The fan is operating based on the electricity directly from power supply.
• When the fan is not operating & connect with power supply (Charging Mode):
  • The built-in battery is undergo charging with ‘F’ blinking on display panel.
  • ‘F’ will stop blinking once battery is full.
• When the fan is operating & not connecting with power supply (Cordless Mode):
  • The fan will operate utilizing the electrical energy from built-in battery.
  • The fan will have different operating time based on different fan speed setting.
  • The higher the fan speed setting, the faster the fan will stop operation.

WARNING: Please do not manually adjust the direction of neck when the fan is swinging. If possible, please turn off the swing function and turn off the unit before you adjust the vertical swing angle of this fan.

How to fold the fan:

• Hold the fan and press the button to unlock (Figure 7), then fold the fan accordingly (Figure 8).
• The operating range for automatic horizontal swing angle of this floor fan is 55°, while manual vertical swing angle is 180°.
• Please do not twist the neck of fan more than the recommended operating range.

SAFETY INSTRUCTION

WARNING: Please pay particular attention to the following safety instructions to reduce the risk of electrical shock, fire or injury to users.

• Do not insert fingers or foreign objects into the fan blade while unit is operating.
• Do not operate the unit if the plug is damaged or the connection to the power supply is loosened.
• Do not touch the plug or intend to operate the fan with wet hands.
• Please disconnect the power supply before cleaning the fan to avoid electric shock resulting from poor insulation or fire from short circuit.
• Please do not damage the plug as it might cause electric shock, excess heat or fire.
• Do not operate the unit near or on hot object such as stove or heater or where it may come into contact with steam or fire.
• Avoid operating the unit in location where grease or oily smoke is generated such as kitchen.
• Do not operate when using aerosol insecticides or in rooms where there is oily residue, incense, sparks from lit cigarette, chemical fumes in the air or in high humidity conditions such as a toilet and bathroom.
• Do not use corrosive cleanser to clean the fan as it may damage the surface.
• If the plug or charging port are damaged, it must be replaced by Acson authorized personnel.
• Do not dismantle and alter the spare parts of this fan. If the unit is not working, please contact Acson authorized personnel for assistance.
• Only Acson authorized technicians should be appointed to service this fan. Please contact the nearest Service Centre for maintenance or repair.
• Please locate the unit on flat and stable surface. If you place the unit on a heavily carpeted area, the unit might slightly vibrate.
• Avoid operating the unit in location where the unit is exposed to condensation or drastic temperature change.
• Please keep the unit under room temperature and away from direct sunlight exposure.
• Please shut down the power supply and turn off the unit during emergency or evacuation.
• This fan can be operated by children aged 10 years and above. Persons with reduced physical, sensory or mental capabilities or lack of experience could operate the unit under proper supervision concerning use of the unit in a safe way and understand the hazards involved.

MAINTENANCE

How to detach the front grille:

• It is recommended to clean the unit regularly after using for 2 to 3 months depending on the frequency of usage.
• Locate the screw at lower part of fan grille and remove it with a Philips head screwdriver. Hold the front grille and turn anticlockwise to dismantle it (Figure 9).
• After the front grille is opened, grip and turn the cap in a clockwise direction to release the fan blade (Figure 10).
• The front grille and fan blade could be dismantle for cleaning purpose (Figure 11), please do not wash it directly under the tap.

How to install the front grille:

• Align the front and rear grille by attach them together around 10mm of effective distance (Figure 12), then rotate it until the front grille is tight (Figure 13).
• Fix the screw back to its original position.

Cleaning:

• When the unit surface is dirty, please wipe it with damp cotton swab or soft cloth. The water temperature should lower than 40°C.
• Please disconnect the power supply prior to any cleaning action. Do not wash the unit directly under water tap. Do not immerse the unit in water.
• Do not use volatile liquid nor detergent to wipe the unit, else it might lead to electric shock or damage on surface.

TROUBLESHOOTING

If the unit could not perform normally, please check the following troubleshooting guidelines.

loosen or not insert properly.

| Pull out the adapter and plug again.
Abnormal power supply.| Relocate the unit and

connect to appropriate power supply.

Low battery or no

battery.

| Please charge the fan.
Remote control no battery.| Please replace the battery of remote control or use the control panel at the fan

instead.

Adapter is damaged.| Contact Acson authorised personnel for assistance.
Abnormal

noise

| Fan blade crack.
Motor damage.
The front grille could not be

detached.

| The screw located at the bottom of grille is

not removed.

| Remove the screw with a Philips head screwdriver.
Display panel

keep blinking.

| Low battery.| Please charge the fan.
The fan could

not be charged.

| Charging could not

be performed when the fan is turned on.

| Please turn off the fan before charging.

IOM-AFF-2101

While care has been taken to ensure that information contained in this document is true and correct at the time of publication, changes in circumstances after the time of publication may impact on the accuracy of this information. Acson Malaysia Sales & Service Sdn Bhd give no warranty or assurance, and makes no representation as to the accuracy or reliability of any information or advice contained in this document, or that it is suitable for your intended use.

Acson Malaysia Sales & Service Sdn Bhd (129688-D)
Lot 4, Lorong 19/1A, Seksyen 19, 46300 Petaling Jaya, Selangor Darul Ehsan, Malaysia.
Pilot Line: 03-7964 8200 / Customer Careline: 1300-22-3344 Fax : 03-79569909

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>