iWALK MXB008 Wireless Powerbank User Guide
- June 13, 2024
- iWALK
Table of Contents
iWALK MXB008 Wireless Powerbank
Product introduction
Charge yo1r phone or devices
Recharge your PowerGrlp Slim
Power the power button to use the, Pass-through Charging
When charging and dlsclierglng, gMI priority to fully cllarglng the moblle phone and then tully charging the mobile power supply
Specifications
Product Name: PowerGrip Slim
Model No.: MXB008
Capacity: 5000mAh(3.85V /19.25Wh)
USB-C Input: 5V == 3A,9V == 2A, 12V = 1 .5A
USB-C Output: 5V = 3A,9V = 2A, 12V = 1 .5A
Wireless Charging : 5W/7.?W/10W/15W
Size: 103.6×66.5x14mm
Weight: 11 9g
Warranty Card
Thank you for purchasing the iWALK product.
Our product’s warranty period is 1 2 months starting from the date of
purchase. Within the warranty period,free service will be provided to the
consumer.If the product has any quality problems(requiring warranty card with
distributor’s official stamp and valid S/N).
- This wireless charger is not compatible with non-MagSafe phone cases, such as Otterbox Defender cases.
- Do not use an adapter with an output of 5V/1 A (5W) or less.
- Wireless chargers make charging more convenient than wired chargers, but confined by current wireless technology, their charging speed is slower than that of wired chargers.
- High temperatures will reduce charging speed and restrict power, which is something that happens to all wireless chargers. It is recommended that you charge your device in environments with temperatures below 25°C / 77°F.
- Both the protective phone case and the position of your device on the wireless charger will affect the charging speed. The farther it is placed from the center of the wireless charger,the slower the charging speed will be.
IMPORTANT SAFETY INSTRUCTIONS
Please make sure to notice the following reminder:
- Please store this product in a cool and dry place. Do not place this product in a car, kitchen, or other high-temperature or humid environments. It must not be exposed to water or heat, and should not be placed near an open flame to prevent any potential hazards.
- Please charge the product by using the matched charging device. Don’t use the power supply, charger, charging line to charge the product in case cause damage to the product or lead to fire hazard to cause personnel damage and other adverse consequence.
- The working temperature shall fall between o•c and 40°C (32°F-104°F).
- Please don’t dismantle the produpt. If the product needs to service or maintenance, please contact the after-sale maintenance personnel of the manufacturer to assist to process, so as to avoid causing the damage to the product or other dangerous.
- If not used for a long period of t ime, the product shall be charged and discharged once every three months.
- When charging, the product may be hot, which is normal and there is no need to worry.
- Under normal use, battery performance may gradually degrade in a few years.
- Improper use, falling or excessive force may damage the product.
- When disposing of old and useless batteries, please separate the batteries of different electrochemical systems.
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of device a distance of 0 cm surrounding the device and 0 cm above the top surface of the device must be respected.
U20 GLOBAL CO.,L TD.
Head Office/Manufacturer: U2O Building,Huanzhu Road 385,Jimei,
Xiamen,Fujian,China U.S. Office: 206 Terminal Drive Plainview, NY 11803
Dubai Logistic Center : 201, Atrium centre, Bank Street, Bur Dubai, UAE.
Korea Office : 4.19-ro 13-gil, Ganbuk-gu, Seoul, Korea
EU Logistic Center: A. Hofmanweg 75-2031 BH Haarlem, Netherland
www.iwalkworld.com/Service
**Service@iwalk.net
US 1-888-961-5888 I 24/7 service
UK 44-20-3885-0855 I 24/7 service
CN 400-8855-698 I Mon-Fri 09:00-17:00
Head Office 86-592-5030-771 /780 I Mon-Fri 09:00-17:00
@iWALK.Fans @iWALKKOREA @iWALKJAPAN**
Documents / Resources
|
iWALK MXB008 Wireless
Powerbank
[pdf] User Guide
SXQ-MXB008, SXQMXB008, MXB008, MXB008 Wireless Powerbank, Wireless Powerbank,
Powerbank
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>