Billi ASNZS 3500.1 Filter Tap Round Slimline Dispenser Installation Guide
- June 13, 2024
- Billi
Table of Contents
Installation guide
Filter Tap
Version 11/2021
Installation requirements.
IMPORTANT: This Billi appliance is to be installed by a licensed trades person
in accordance with AS/NZS 3500.1 and AS/NZ 3500.2 and in compliance with
applicable state regulatory requirements.
For correct operation of this appliance, it is essential to observe the
manufacturer’s instructions.
- 22mm hole required
Hoses deleted for clarity
15mm stop tap (installed by plumber)
Diagram 1
- Locking bush
- Locking nut
Diagram 2
- 1/4 filter water outlet
- 1/4 filter water inlet
- 15mm stop tap
- PLV
Diagram 3
Water Supply
The Filter tap must only be connected to a cold water supply. A 15mm stop tap
(not supplied) is to be installed in an easily accessible position within
450mm from the Filter Tap water inlet.
1. Determine Component Location
Determine the location of each of the components, taking into account the tube
lengths and space available (see Diagram 1).
2. Plan Dispense Position
Determine the position of dispenser mounting hole in sinktop or benchtop. Hole
size required is 22mm.
3. Install Components
a) Connect the Pressure Limiting Valve (with blue mini-tap ) to the mains
water supply.
b) Connect one end of the white hose provided to the blue mini-tap and connect
the other end of the white hose to the Filter Module fitting labeled “IN”.
c) Mount the Filter Module in an easily accessible position, preferably close
to the front of the cupboard to allow for filter changes.
d) After establishing where the dispenser can be installed (within the limits
of the hose length from the dispenser to Filter Module.) punch a 22mm hole for
mounting the dispenser.
e) Mount the dispenser by first passing the blue hose through the hole and
then fitting the locking bush and lock nut to the threaded mounting shaft (see
Diagram 2). Tighten the locknut. Reconnect blue hose to the out fitting.
Commissioning Unit
Turn on the mains tap and then turn on the blue mini-tap and check for leaks.
If no leaks are detected, rotate the lever on the dispenser until a good
stream of water is present. Note: There may be air bubbles in the water at
first as the water filter is dry.
Allow 2-3 minutes of continuous run to ensure all air bubbles have been flushed from the system.
For service and support contact Billi on 1800 812 321 or email service@billi.com.au
Billi Australia Pty Ltd
42 Lucknow Crescent, Thomastown
Victoria 3074 Australia
Telephone +61 3 9469 0400
Facsimile +61 3 9469 0499
Designed and manufactured in Australia.
As Billi Australia Pty Ltd has a policy of continual improvement, all details are subject to change without notice. All goods are sold subject to our published terms and conditions. Billi is a registered trademark. 0618
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>