ARB 5680010 Rear Bar Wide Narrow Flare Instructions
- June 13, 2024
- ARB
Table of Contents
ARB 5680010 Rear Bar Wide Narrow Flare Instructions
WARNING
ALSO, NOTE THE FOLLOWING:
- This product must be installed exactly as per these instructions using only the hardware supplied.
- In the event of damage to any component, contact your nearest authorised ARB stockist.
- Do not use this product for any vehicle make or model, other than those specified by ARB.
- This product or its fixing must not be modified in any way.
- The installation of this product may require the use of specialized tools and/or techniques.
- It is recommended that this product is only installed by trained personnel.
- These instructions are correct as at the publication date. ARB Corporation Ltd. cannot be held responsible for the impact of any changes subsequently made by the vehicle manufacturer.
- During installation, it is the duty of the installer to check correct operation/clearances of all components.
- Work safely at all times.
- Unless otherwise instructed, tighten fasteners to specified torque.
ARB 4×4 ACCESSORIES
Corporate Head Office
42-44 Garden St Kilsyth, Victoria AUSTRALIA 3137
Tel: +61 (3) 9761 6622 Fax: +61 (3) 9761 6807
Australian enquiries North & South American enquiries Other international
enquiries [email protected]
[email protected]
[email protected]
www.arb.com.au
Last Rev Date: 19/11/2021
Fitting instructions# 37800126
Copyright © 2021 by ARB Corporation Limited. All rights reserved, this
document must not be reproduced without the express authority of ARB
Corporation Ltd
GENERAL CARE AND MAINTENANCE
By choosing an ARB Bar, you have bought a product that is one of the most
sought after 4WD products in the world. Your bar is a properly engineered,
reliable, quality accessory that represents excellent value. To keep your bar
in original condition it is important to care and maintain it following these
recommendations:
As part of any Pre Trip Preparation, or on an annual basis, it is recommended
that a thorough visual inspection of the bar is carried out, making sure that
all bolts and other components are torqued to the correct specification. Also
check that all wiring sheaths, connectors, and fittings are free of damage.
Replace any components as necessary. This service can be performed by your
local authorized ARB Stockist.
FITTING REQUIREMENTS
REQUIRED TOOLS FOR FITMENT OF PRODUCT:
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT:
PARTS LISTING
PREPARATION OF VEHICLE
FINAL CHECKS:
- Check operation of parking sensors
- Check operation of all lights.
IMPORTANT: Check that all wiring is clear of sharp edges and pinch points. Adjust any wiring to clear the bar or mounts by a minimum of 15mm.
FINAL PRODUCT ON VEHICLE
References
- ARB 4x4 Accessories Australia - Your Partner In Adventure
- ARB 4x4 Accessories Australia - Your Partner In Adventure