REDBACK BT2-MSG/SS 316 Pole Clamps Instructions
- June 13, 2024
- redback
Table of Contents
REDBACK BT2-MSG/SS 316 Pole Clamps
Product Information
The product is a BT2-MSG/SS assembly kit designed for securing poles. It includes the following components:
- 2 x Struts
- 4 x Adjustable Clamps
2 x Threaded Bolts/li
- 12 x Washers
- 8 x Large Nuts
- 4 x Square Recessed Bolts
Please note that depending on the diameter of the pole, you may only need to use 2 adjustable clamps (1 clamp per strut). If you have any questions or need assistance, you can contact Redback Racks at 1300 882 447.
Product Usage Instructions
- Insert one square recessed bolt into the square hole on the strut and through one of the adjustable clamps.
- Place two washers on top of the bolt, followed by one large nut. Tighten the clamp and strut together.
- Repeat steps 1 and 2 for the remaining 3 clamps.
- Use the threaded bolts to tighten the clamps according to the diameter of the pole.
- Tighten and secure each clamp with a washer and a large nut.
- If there is excess clamp after tightening to the pole, it is recommended to fold it back for a neater finished product.
Package Content
Assembly Instructions
- Insert square recessed bolt into the square hole on the strut and through adjustable clamps.
- Place two washers on top of bolt, followed by one large nut. Tighten the clamp and strut together. Repeat this for the remaining 3 clamps.
- Use the threaded bolts to tighten clamps to suit pole diameter. Tighten and secure with washer and large nuts as per picture
- If you have excess clamp after tightening to pole, we recommend folding this back for a neater finished product.
Please note: Depending on pole diameter, you may be able to use 2 adjustable clamps (1 clamp per strut).
Redback Racks
- 1300 882 447
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>