VGR V-282 Professional Hair Clipper User Manual
- June 13, 2024
- VGR
Table of Contents
VGR V-282 Professional Hair Clipper
COMPONENTS OF HAIR CLIPPER
- Stainless steel blade
- Taper lever
- ON/OFF switch
- LED display
- Hanging loop
- Cutting guide combs (1.5/3/4.5/6/10/13mm)
- Comb
- Cleaning brush
- Oil
- USB charging cable
- Protection cap
SAFETY WARNINGS
This appliance may be used by children of more than 8 years of age, persons
with physical, sensory or mental capabilities or inexpert persons only if they
have been previously trained in using it in a safe manner, and only if they
have been informed of the dangers the product can cause.
Children may not play with the appliance. Children may not clean or carry out
any maintenance on the appliance without adult supervision.
- Professional blades
- 2000mAh Lithium battery
- Taper Lever Multi-cut clipper only
- Cord / Cordless
GENERAL SAFETY INSTRUCTIONS
It is advisable to save these instructions for a future use.
Always check the appliance before you use it. Do not use the appliance if it
is damaged, as this may cause injury. Always replace a damaged part with one
of the original type.
Do not open the appliance to replace the rechargeable battery.
This appliance is not washable. Never immerse the appliance in water and do
not rinse it under the tap.
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids, such as petrol or acetone to clean the appliance.
IMPORTANT
This clipper has a built-in rechargeable battery. Do not throw into fire,
apply heat, or charge, use, or leave in a high temperature environment.
The appliance should not be used on animals.
OIL BOTTLE
Keep out of reach of children. Do not swallow. Do not apply to eyes. Dispose
of properly when empty.
CUTTING GUIDE COMBS
By use of the 6 cutting guides provided, you can adjust the length of the trim
up to a maximum of 13mm (with the guide comb inserted).
The cutting lengths are as follows:
Without a guide comb: approximate size is 0.8mm to 2.0mm. With guide combs: from 1.5/3/4.5/6/10/13mm. The length of the cut is shown on the guide comb.
IMPORTANT: The device must always be turned off when inserting or removing a cutting guide.
- It is advisable to begin with the highest setting and then reduce the setting until vou reach the desired hair length.
- Push the on/off switch. Hold the comb with the angled edge against your beard and guide the clipper against the direction of the hair growth.
- To avoid clogging the comb with hair, clean it from time to time with a brush.
USB CHARGING
- The hair clipper is completely handy to carry and can be charged anywhere with the USB cable.
- Rechargeable – Comes with built-in battery, a full charging time 3 hours to offer around 200 minutes of running time.
- Charging through USB cord(comes with the clipper) Charge the device by connecting with the power bank or adapters(5V=1), or computer.
- The LED display shows battery power left.
Note: This product is for cord and cordless use.
CLEANING AND MAINTENANCE
- Before starting cleaning the appliance, always switch it off and unplug it.
- Clean the unit with a damp and soft cloth.
- Never use detergents and solvents to clean the appliance.
- After having used the appliance, use the cleaning brush to clean the device in order to remove any hair from the cutting blade.
- In order to grant a long and good performance to the appliance, it is advisable to clean and oil often the appliance.
- Remove hair from the cutting blade using the cleaning brush, put 2 or 3 oil drops and allow the machine to run for several seconds so that the unit can lubricate properly.
- Fit the protective cap after use; keep the device only with the fitted protective cap.
Noted: The cutting blade is fixed by screws.
TECHNICAL FEATURES
- ON/OFF switch
- LED display
- Complete charging time: 3 hours
- 200 minutes of continuous operation
- Power supply: 5V1A
– Battery: 2000mAh lithium battery
SYMBOL
This item is made in conformity with CE
DISPOSAL
The device (including its removable parts and accessories) must not be
disposed of together with municipal waste at the end of its life, but in
compliance with European Directive 2012/19/EG. Since it must be handled
separately from household waste,either carry it to a separately-collected
waste disposal centre for electrical and electronic appliances or give it back
to the retailer on purchasing a new device with the same purpose. Any
infringement will be severely prosecuted.
The built-in rechargeable battery contains substances that may pollute the
environment. Always remove the battery before you discard and hand in the
appliance at an official collection point. Dispose of the battery at an
official collection point for batteries
First unplug the product and let the motor run until the battery is completely
empty.
Remove both side panels from the appliance with a screwdriver.
Lift the power unit out of the appliance.
Specifications and designs are based on the latest information available at
the time of printing and subject to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>