TANDELTA OQDe Display Kit User Guide
- June 13, 2024
- TANDELTA
Table of Contents
DISPLAY KIT I SENSE-2
QUICK START GUIDE
WHAT’S IN THE BOX?
CONFIGURE
**** You MUST configure the OQSx-G2 Sensor using CADS before configuring the OQDe.
-
Plug in the configuration cable and allow the update/installation of drivers.
-
Install CADS by scanning the QR code (right) or go to: www.tandeltasystems.com/support/
-
Connect the sensor to the configuration cable.
-
Run CADS and configure the sensor for the correct communications and oil type.
-
Search for active Wi-Fi networks on PC or Mobile device.
Connect to“Tan Delta OQDe” Wi-Fi Hotspot. Password = password -
Navigate to Insight by manually going to web address
http://192.168.4.1 or scan the QR Code (right): -
Configure OQDe parameters using Insight, including preferred units and warning and alarm levels.
NOTE: Default oil condition warning and alarm levels are set for a diesel engine application.
INSTALL AND CONNECT
ORIENTATION
Not recommended for engines
**** Sensor may not function if installed incorrectly
Troubleshooting
- Check configuration.
- Refer to Master User Guide available at: www.tandeltasystems.com/support
- Contact: support@tandeltasystems.com
INTERPRETING OIL CONDITION
SUPPORT-FAQ
If you have any issues, please read the tips below before contacting us for further support.
1. Does the sensor require cleaning?
No, cleaning is required once the sensor is installed. However, when using the sensor for testing offline samples (i.e. MOT Kit), then cleaning between samples is essential.
2. Where can I find the list of Event Codes for the Display Express?
The Master User Guide linked at the botom of this page contains the list of Event Codes, which can be displayed on the device.
3. I cannot see my oil in the database, so I have used an oil which I believe is close, but the sensor isn’t working?
4. How do I update the software?
Software updates will happen automatically. You will be prompted to accept when one is available. If you are provided an installer by Tan Delta, please uninstall any previous versions of software before installing the new one.
5. How do I remove the software?
Simply go into your control panel and remove the software.
You can find further information in the Master User Guide on the support page of ourwebsite. If you have any further questions, please contact our support team by email: support@tandeltasystems.com who will answer no later than the next working day.
Alternatively, refer to Master User Guide
available at:
www.tandeltasystems.com/support
www.tandeltasystems.com
support@tandeltasystems.com
Copyright © Tan Delta Systems PLC
References
- Tan Delta Systems - Tan Delta Systems PLC
- Oil Database - Tan Delta Systems PLC
- Support | Tan Delta Systems
- Support | Tan Delta Systems
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>