TIE DOWN 40676 TranzVolt G2 Solar Tilt Back Platform Instruction Manual
- June 13, 2024
- TIE DOWN
Table of Contents
TranzVolt G2
Solar Tilt Back Platform
Model #40676
The fully assembled tracks and TranzVolt should be located in its final work
space and fully secured at the top of the roof.
The solar platform will require minor assembly out of the box and some
reassembly from job site to job site.
STEP 1 Solar Tilt Back Platform Assembly
- Remove the tilt back assembly are all hardware from the box.
- Lay the tilt back assembly flat on the ground with the pivot hinge upward and the top rollers on the ground. Lift and flip the lower hinged tilt back section 180 degrees so it lays flat on the ground surface. See Fig 1-1.
- Insert the tethered safety pins in the pivot hinge locking the frame in place. See Fig. 1-2.
STEP 2 Mounting the Solar Platform
- It is recommended that two workers mount the solar platform.
- Position the solar platform vertically in line with the ladder tracks.
- Align the pivot mounting holes on the solar platform (just below the frame hinge) with the front mounting holes on the carriage frame as shown in Fig. 1-3.
- Insert quick release pins on each side of the carriage frame/solar platform.
STEP 3 Mounting the side arms and panel rest
-
Using the spring button located on the end of the side arm, slide the side arm into the side of the solar panel frame.
Adjust to desired position. See Fig. 2-2.
Repeat on the opposite side. -
Slide panel rest into the bottom of the frame adjust to your desired position. Secure with safety pin. See Fig. 2-3.
Before using the TranzVolt double check and make sure that the wheels on the
panel frame align with the track. See Fig. 2-4.
Test run the full TranzVolt by raising
the platform making sure the top tilt back rollers rides along the tracks and
the platform tilts downward as it reaches the top cap in a smooth operation.
The Solar Tilt Back Platform is ready to use.
https://www.tiedown.com/pdf/tranzvolt_g2_assembly_e1930.pdf
TranzVolt G2 Operations Manual
WARNING: This product can expose you to chemicals including Nickel, which
is known to the State of California to cause cancer. For more information go
to: www.P65Warnings.ca.gov
Instruction #08430 (E1939 – Rev. 10/7/22)
404-344-0000 •
www.tiedown.com
605 Stonehill Drive SW, Atlanta, GA 30336
sales@tiedown.com
Safety Products Division
605 Stonehill Drive SW, Atlanta, Georgia 30336
800-241-1806 •
404-344-0000 •
www.tiedown.com
ISO 9001:2015 Certification
Intellectual property of TIE DOWN Inc. ©2022 TIE DOWN, Inc.
Instruction #08430 (E1939 Rev. 10/7/22)
References
- P65Warnings.ca.gov
- Tie Down | Custom Manufacturing Solutions for Roofing, Safety, Marine and Much More
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>