ifollower 989-303 2.4GHz Mini Remote Control Stunt Car Instruction Manual

: June 13, 2024
: ifollower

Table of Contents

ifollower 989-303 2.4GHz Mini Remote Control Stunt Car
Package Contents
How to charge the car
How to install batteries into the remote
Operation Direction
FCC
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ifollower 989-303 2.4GHz Mini Remote Control Stunt Car

Warning:

Please read this instruction manual carefully before playing this car.
Children aged under 3 need adults’ supervision while playing.
This model is not waterproof, please don’t put it in water.

MINI RC CAR

Package Contents

How to charge the car

Turn off the car,
Put the C port of the charging cable into the car.
Plug the USB port of the charging cable inte a 5V USB-A charging adapter
The red indicator lightinside the car botton willbattery is charging. when it is fully charged the tight will go out

How to install batteries into the remote

Press down on release button (A) with a pen orscrewdriver to slide down the battery cover (B).
Install two AA batteries as shown.
Push up the cover to lock the remote.

How to connect the controller

Make sure your car is full charged and the remote batteries are installed first.
Press the red button to turn on the remote,thered light will flash.
Turn on the remote bypressing the red button,the LED will flash for one timeand auto pair to the car, and you are ready to drive now.

Note:
The red LED will be off after signal paired, but it will flash each time when you push the button.

Operation Direction

180° tumble: under low speed mode, push the left stick forward or backward for a while and pull it back suddenly.

self-rotation: keep the right stick turning right or left.

Forward/Backward: Push the left stick forward or backward. ifollower-989-303-2.4GHz-Mini-Remote-Control-Stunt-Car-
fig-8

Battery information

Car Battery: 1x180mAh lithium ion internal rechargable battery
Remote Control Battery : 2×1.5V AA batteries(not included).

The Waste Electrical and Electronic Equipment Directive(WEEE Directive) is the European community directive on waste electronic and electronic equipment,which became European law in February 2003. The main purpose of this directive is to prevent electronic waste. Recycling and other forms o waste recovery should be encouraged to reduce waste.The symbol (trash can ) on the product and on the packing means tha used electrical and electronic products should not be disposed of with general householdt waste. It is your responsibility to dispose of all your electronic or electrical waste at designated collections points. For more information about the correct disposal of electrical and electronic equipment recycling and collection points please contact your local authorities, waste management companies, your retailer or the manufacturer of this device.Batteries are marked with the symbol of a crossed out bin. This symbol indicates that empty batteries or accumulators which can no damage to health and to the environment. Please use the return and collection systems available in your country for the disposal of the waste batteries.

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliancecould void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction

After-Sales Service