rhiwA Electrical module for the Easy Aero roof fan Instruction Manual
- June 13, 2024
- rhiwA
Table of Contents
INSTALLATION INSTRUCTIONS FOR EASY AERO
POSITIONING EASY AERO
If you have 1 fan, place it as close as possible to the centre point of the roof which can be determined by measuring from the bulkhead to the tailgate or rear doors.
If you have 2 fans, place them diagonally so that they are evenly spaced. Divide the space into 3 equal parts lengthwise (measured from the bulkhead to the tailgate or rear doors) and place the Easy Aero 1/3 from the front and 1/3 from the rear and widthwise halfway along the half-diagonal.
DRILLING
Mark out the holes using the drilling template provided and create the holes in the roof using a 90 mm punch (available upon request).
POSITIONING
2. Place the foam gasket underneath the Easy Aero and push the tubes through
the holes with the grille at the front.
Note: the foam gasket should be fitted at all times!
The foam gasket is available separately in a range of thicknesses: ask our
specialists for advice on the correct thickness to use.
To install the Easy Aero Electric, continue to step 5 (see other side).
FINISHING
Screw the cover plate onto the inside of
the roof using the screws provided. The roof fan is installed: easy!
Note: Do not install behind objects that could affect the flow of air such as
rotating warning lights, aerials or spotlights.
Pay attention to ridges and uneven areas on the roof. The Easy Aero can also
be installed underneath a roof rack.
In that case, always install the Easy Aero between the bars rather than
underneath them.
NB: The number of fans required will depend on the individual situation (M3,
load, etc.). Ask our specialists for advice.
REMOVE EXISTING COVER PLATE
Step 4 is only needed when installing an existing Easy Aero, as this cover plate is only used for the mechanical version. Detach the screw part (unclick). Unscrew four screws and remove the cover plate.
EASY AERO ELECTRIC
Check whether the intermediate piece and the cover plate of the Easy Aero Electric has a foam edge. If this has been supplied separately, apply the foam edge yourself to both the intermediate piece and the cover plate.
Secure the intermediate piece using the four screws.
Please note: Install the fan in the correct direction: on the outlet side
(back).
Place the finger protector (grille) and fan in the cover plate correctly (with the arrow pointing upwards).
Connect the wiring (connection method depends on customer requirement and vehicle options).
Secure the Easy Aero module cover plate using the three screws provided.
RESULT
The roof fan is installed: easy!
OPTIONAL: INSTALLING LIGHTS
Drill holes in the stipulated places on the inside of the cover plate.
Screw down the lights and click the cover plates on top.
Transport & Logistics
+31 (0)88 130 66 90
info@imbema.com
imbema.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>