Yale AYR202-ZWV Z-wave Plus Electronic Locks Module Instruction Manual
- June 13, 2024
- Yale
Table of Contents
Yale AYR202-ZWV Z-wave Plus Electronic Locks Module
Installing the Z-Wave® Plus Module
IMPORTANT: the batteries must be removed prior to removing and/or
inserting the network module: 
Enrolling/Unenrolling the Network Module
This device is a security enabled Z-Wave Plus product that is able to use encrypted Z-Wave Plus messages to communicate to other security enabled Z-Wave Plus products. This device must be used in conjunction with a Security Enabled Z-Wave Controller in order to fully utilize all implemented functions. This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
To Enroll/Add the Module (Inclusion Mode):
- Enter the 4-8 digit Master PIN code followed by the key.
- Press the key followed by the key.
- Press the key followed by the key.
To Unenroll/Remove the Module (Exclusion Mode):
- Press the 7 key followed by the key.
- Press the 3 key followed by the key.
Factory Reset – If No Controller:
- See the Lock Installation Manual
- Please use this procedure only when the network primary controller is missing or otherwise inoperable.
For System Integrators: Specific Z-Wave Plus association and parameter information for your lock is available at YaleHome.com/ZwavePlus.
Warning: Changes or modifications to this device, not expressly approved by Yale Security Inc. could void the user’s authority to operate the equipment.
FCC
Contain FCC ID: U4A-YRHCPZW FM0
Model: YRMZW2-US
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Industry Canada:
- Contain IC: 6982A-YRHCPZW FM0
- Model: YRMZW2-US
Section 7.1.2 of RSS-GEN Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Section 7.1.3 of RSS-GEN This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter 6982A-YRHCPZW FM0 has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Product Support
- Tel 1-855-213-5841
- www.yalehome.com
Yale Locks & Hardware is a division of Yale Security Inc., an ASSA ABLOY Group company.
Yale® and Yale Real Living® are registered trademarks of Yale Security Inc., an ASSA ABLOY Group Company.
Other products’ brand names may be trademarks or registered trademarks of their respective owners and are mentioned for reference purposes only. Copyright © 2017, Yale Security Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
YALE, with its unique global reach and range of products, is the world’s favorite lock the preferred solution for securing your home, family and personal belongings.
ASSA ABLOY is the global leader in door opening solutions, dedicated to satisfying end-user needs for security, safety and convenience.
FAQs
What is the Yale AYR202-ZWV Z-wave Plus Module?
The Yale AYR202-ZWV Z-Wave Plus Module is an add-on for Yale Real Living Locks that enables Z-Wave smart home and alarm system compatibility.
Which Yale locks are compatible with this module?
This Z-Wave Plus Module is compatible with the following Yale locks: YRD216, YRD226, YRD246, YRD256, YRD416, YRD426, YRD446, NTB620, and NTB610.
How do I install the Yale Z-Wave Plus Module?
The module plugs into the back of your Yale Assure Lock, right above the battery compartment.
Can I use my computer or phone to program the lock once the module is installed?
Yes, the Z-Wave Plus Module allows you to add and delete codes using your computer or phone. You can even set up restrictions for days, weekly access, specific dates, and time ranges.
What controller types are compatible?
The module works with various smart home controllers including Iris, Wink, Vera, and SmartThings.
What is the style and finish of the module?
The module has a modern style with a brushed finish and is colored green.
What are the dimensions and weight of the module?
The package dimensions are 3.9 x 2.32 x 1.18 inches, and it weighs 1.13 ounces.
Do I need a separate hub to use this module?
Yes, you'll need a compatible Z-Wave controller like Iris, Wink, Vera, or SmartThings to use this module effectively for smart home integration.
What is Z-Wave Plus?
Z-Wave Plus is a certification standard for a more advanced series of Z-Wave wireless protocol products, which offer extended range and battery life compared to the original Z-Wave products
Can I share access to the Yale lock once the module is installed?
Yes, depending on your Z-Wave controller's software, you can share access to the Yale lock with family and friends.
Is the module weather-resistant?
The module is designed to be installed indoors, inside the lock, so it does not need to be weather-resistant.
Does installing the module void the lock's warranty?
Installing the Z-Wave Plus Module will not void the warranty of your Yale lock as long as it is installed correctly according to the guidelines provided.
Download This PDF Link: Yale AYR202-ZWV Z-wave Plus Electronic Locks Module Instruction Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>