Stork Vital LAB11992A Smart Home Baby Monitoring System User Guide

June 13, 2024
Stork Vital

Stork Vital LAB11992A Smart Home Baby Monitoring System

What’s in the box?

  • Sensor

  • Medium Boot (Size 4 Strap Pre-Attached)

  • Small Boot (Size 3 Strap Pre-Attached)

  • Hub

  • Hub Power Cable

  • Sensor Magnetic Charge Cable and Cable Clip

  • 2 X 5W Charge Adapters

  • Size 1 and Size 2 Straps

Not intended for use as a medical device or to replace a medical device. Do not use it to diagnose, cure, treat, alleviate, or prevent any disease or health condition.

Charge the sensor

  • Plug the Sensor Magnetic Charge Cable into the 5W power adapter.

  • Peel and stick the cable clip to secure the sensor charge cable.

  • Connect the magnetic end of the cable to the sensor. Fully charge the sensor before use.

Pair the sensor to the app

** Download the Stork app and follow instructions.
**

The app screens shown in this document might differ from the actual ones displayed in the app

Add straps to sensor and boot

Size 1 strap (for newborn foot)

Remove sizes 1 and 2 from paper sleeve.

Remove sizes 1 and 2 from paper sleeve.

Insert Sensor Into Boot

  • Insert the sensor at an angle, toe end first.

  • Press down to secure the sensor. The sensor should sit flush in the boot.

Apply Boot to Either Foot

**

Check the Strap Length
**

Boot Sizing (Using Small Boot As Example)

OK for toes to overhang – boot DOES NOT fit like a typical shoe.

IMPORTANT NOTE

Make sure all sensors are making good contact with the baby’s skin to ensure correct measurement.

Strap Tightness

****

Boot and sensor maintenance

Remove Sensor

To remove the sensor, push it from the opening at the bottom of the boot.


Cleaning Sensor and Boot

Remove the sensor and place just the boot (and the straps if desired) in the washing machine.

Do not put the sensor in the washing machine

Dampen a cloth with water to wipe the components of the Stork System (sensor is shown in the example). Bleach wipes or 70% isopropyl alcohol can also be used.
Do not use household cleaning agents.

Set up the hub

Place the hub on top of a nightstand, side table or a cabinet in the same room as the baby’s crib to ensure a strong connection.

Attach USB Cable to Hub
  • Plug the hub power cable into the back of the hub.


  • Plug the hub into a wall socket.

  • Plug the other end of the hub power cable into the 5W power adapter.

Pair the hub to the app

Use the same app you downloaded for pairing the sensor.

Customer Support

OWNER’S MANUAL
Refer to the online manual for other functions, information, and operation details.
masimostork.com/vitals-user-manual

Documents / Resources

| Stork Vital LAB11992A Smart Home Baby Monitoring System [pdf] User Guide
LAB11992A, LAB11992A Smart Home Baby Monitoring System, Smart Home Baby Monitoring System, Baby Monitoring System, Monitoring System
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals