anko 43265077 Highchair Booster Seat Instruction Manual
- June 13, 2024
- Anko
Table of Contents
anko 43265077 Highchair Booster Seat
Product Information
The Highchair Booster Seat is designed for children aged 6-36 months, with a maximum weight capacity of 15 kg. It comes with a tray and securing straps for added safety and convenience. Please note that the photos and illustrations in this manual are for reference only, and the manufacturer reserves the right to make changes to the specifications or features without notice.
Parts List
- A x 1 – Booster seat
- B x 1 – Tray
- C x 2 – Securing straps
Assembly Instructions
Unfold booster seat Lift the backrest completely until you hear a click,
indicating that it is in the correct position.
Tray installation
Insert the two plastic hooks of the tray into the armrest slots. Press the
tray downwards until it snaps into place, and you hear aclick. To support the
tray, pull down the plastic bar under the tray and secure it into the slot of
the booster seat. Ensure the tray is fully locked by pulling and gently
lifting it up. Run one of the securing straps into the notch of both C-rings
of the backrest. Once the strap is installed, turn the notch of each C-ring
into the loop. Then run the second securing strap from the right to the left
side at the bottom of the booster seat, following the sequence from fig.1 to
fig.4 to insert the strap on both sides of the seat. Place the booster seat at
the center of a chair that is larger than the booster seat. Adjust the height
of the booster seat according to your needs. Position the booster seat tightly
against the backrest of the adult chair and secure it by fastening the rear
strap around the backrest of the chair. Then secure the bottom strap under the
seat of the chair. Before use, ensure the booster seat is correctly fixed on
the chair to prevent it from moving.
Secure child
To secure your child in the harness, push the buckle into the buckle housing
until they snap into position. Adjust the waist strap to ensure a snug fit for
your child. Always use the secure system when the child is sitting in the
booster seat.
Folding
To fold up the Highchair Booster Seat, fold up the plastic bar under the
tray. Simultaneously push the two buttons at the armrests to lower the
backrest. Then simultaneously push the two buttons on the legs. The product is
very compact and easy to carry or store.
Care & Maintenance To prolong the life of your nursery product, keep it clean and avoid leaving it in direct sunlight for extended periods of time. Clean with a damp cloth using mild detergent. Allow it to fully dry, preferably away from direct sunlight.
Safety Notes
CAUTION:
Read these instructions carefully before assembly and keep for future
reference.
The child may be hurt if you do not follow these instructions.
WARNING:
-
Never leave the child unattended.
-
Always use the restraint system and ensure it is correctly fitted.
-
Always use the chair attachment system and ensure it is correctly fitted before use.
-
Always check the security and the stability of this item on the adult chair before use.
-
Do not use this product on stools or benches.
-
Do not use the chair alone without attaching to adult chair.
-
This product is intended for children able to sit unaided (minimum 6 months) and up to 36 months or a maximum weight of 15kg.
-
Before attaching this product to an adult chair, ensure the chair meets the minimum dimensions shown below.
-
Place the adult chair with the booster seat in a position where the child is not able to use its feet to push against a table or any other structure as this can cause the chair to tip over
-
Adult assembly required.
-
Take care when unpacking and during assembly.
-
Dispose of all packing materials carefully after assembly.
-
Inspect the product before assembly and periodically during use.
-
Never use this product if there are any loose or missing fasteners, joints or broken parts.
-
Any additional or replacement parts should only be obtained from the manufacturer or distributor.
-
Never substitute parts.
Parts List
Assembly
Unfold booster seat
Lift the backrest completely. When reaching the correct position of the
backrest, you will hear a “click”.
Tray installation
Insert the two plastic hooks of the tray into the armrest slots.
Press the tray downwards until it snaps into the correct place. You will hear
a “click”. To support the tray, pull down the plastic bar under the tray and
secure it into the slot of the booster seat.
Check that the tray is fully locked into place by pulling and gently lifting
up the tray.
Height adjustment
To adjust booster seat height, push the two buttons on the sides and push down
the legs.
IMPORTANT: MAKE SURE THE BUTTONS HAVE POPPED OUT BEFORE USE.
Securing straps installation
Run one of the securing straps into the notch of both C-rings of the backrest.
Once the strap has been installed, turn the notch of each C-ring into the
loop. Then run the second securing strap from the right to the left side at
the bottom of the booster seat. Follow the sequence from fig.1 to fig.4 to
insert the strap on both of the right and left side of the seat.
Attaching to an adult chair
Place the booster seat at the center of the chair, ensuring that the chair is
larger than the booster seat. Refer to page 2.
Adjust the height of booster seat according to your needs. Position the
booster seat tightly against the backrest of the adult chair and secure it by
fastening the rear strap around the backrest of the chair. Then secure the
bottom strap under the seat of the chair.
Note: Pass the end of both straps through the slot of buckle then tighten both straps by pulling on the loose ends.
WARNING: Before use, ensure the booster seat is correctly fixed on the chair to prevent it from moving.
Secure child
To secure your child in the harness, push the buckle into the buckle housing
until they snap into position.
Adjust the waist strap to ensure a snug fit for your child.
IMPORTANT: Always use the secure system when the child is sitting in the
booster seat.
Folding
Fold up the plastic bar under the tray.
Simultaneously push the two buttons at the armrests to lower the backrest.
Then simultaneously push the two buttons on the legs.
This product is very compact and easy to carry or store.
Care & Maintenance
To prolong the life of your nursery product, keep it clean and do not leave it
in direct sunlight for extended periods of time.
Clean with a damp cloth with mild detergent.
Allow it to fully dry, preferably away from direct sunlight.
KEYCODE: 43-265-077
MADE IN CHINA
© KMART AUSTRALIA LIMITED
FOR AU / NZ: IMPORTED FOR KMART STORES IN AUSTRALIA AND NEW ZEALAND.
KMART AUSTRALIA – 690 SPRINGVALE ROAD, MULGRAVE, VIC 3170 AUSTRALIA.
KMART NEW ZEALAND – REGIONAL OFFICE C/O KMART PAPATOETOE STORE, HUNTERS PLAZA,
GREAT SOUTH ROAD, PAPATOETOE, AUCKLAND, NEW ZEALAND.
KMART CUSTOMER SERVICE
AU: 1800 124 125 NZ: 0800 945 995
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>