NEFF N17HH10G0 Built In Warming Drawer Instruction Manual
- June 13, 2024
- Neff
Table of Contents
NEFF N17HH10G0 Built In Warming Drawer Instruction Manual
You must note the following Electrical connection
The appliance must only be connected to a earthing contact socket that has
been correctly installed. A socket must only be installed or the power cable
replaced if this is carried out by a qualified electrician, and in accordance
with the appropriate regulations.
The eclfpliance must only be connected using the power cable provided. Connect the power cable to the back of the appliance.
Connecting cables with various plug types are available from after- sales service.
No multi-plugs, multiple connectors or extension leads may be used. Overloading causes a risk of fire.
If the plug can no longer be reached after the installation, a partition must be provided in the phases in the permanent electrical installation in accordance with the installation regulations.
Fitted units
The fitted cabinet must not have a back panel behind the appliances. There
should be a gap of at least 35 mm between the wall and the cabinet base as
well as the rear panel of the cabinet situated above. Ventilation slots and
intake openings must not be covered. Read the information in the installation
instructions for the appliance installed above. Do notinstall the appliance
behind a decorative panel, as this puts the appliance at risk of overheating.
Installation instructions
Inserting the appliance (Fig. 1)
Connect the appliance. Align the appliance flush in the unit and screw it
firmly in place.
Note: Make sure that the connecting cable is not trapped or kinked. The
connecting cable must not come into contact with the rear and base of the
appliance after installation.
Aligning the appliance (Fig. 2)
If the front of the appliance is not flush with the appliance that is installed above it once it is installed, you can align the front of the drawer.
- Remove the appliance that is installed above the drawer.
- Undo the fastening screws at the sides of the drawer and pull the drawer out a third of the way.
- Use an Allen key to turn the set screw on the underside of the drawer (size 5) until the front of the appliance is aligned.
References
- It's Uptime | International® Trucks
- NEFF international - Quality built-in kitchen appliances
- NEFF international - Quality built-in kitchen appliances
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>