Vibe VE-WDOR Wireless Doorbell with Extra Socket Instructions

Vibe VE-WDOR Wireless Doorbell with Extra Socket

OVERVIEW

INSTALLATION

1. Take off the adhesive sticker and paste it underneath the transmitter.
2. Choose a good area, and attach it by putting a little pressure to ensure the tramistter is attached.
3. Plug the doorbell into a regular socket within the operating range.
4. Press button on reciever of ” Music” & “Volume” to choose music and volume.
5. Press ” Music” & “Light Mode” button to choose prefered mode, and the light will light up.

FUNCTION OPERATION

SELF-LEARNING CODE FUNCTION OPERATION

Press and hold ” music” & “light mode” button for about 3 seconds, the bell will ring ( bird voice J. Press the transmitter 2 times within 30 seconds, if the doorbell rings, the pairing is succesfful. If the doorbell does not ring, please press the transmitter again, until the pairing is succesfull. For matching multiple transmitters, please repeat the above operation.

DELETE PAIRING

• Press and hold the “music” & light mode button” about 10 seconds until the bell rings two times. All pairing codes will be deleted.

CAUTION

1. Please do not open PCB or repair without proffesional giude in order to avoide break down of componets.
2. Operating range may be affected by enviromental factors and nearby interference sources.
3. Proper use will prolong life span of wireless doorbell effectively.

WARNING: This product contains a Button Cell Battery. A swallowed Button Cell Battery can cause internal chemical burns leading to death in as little as two hours. Dispose of used batteries immediately. Keep new and used batteries away from Children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. Do not mix with used other types of batteries.

SPECIFICATIONS

• 1300 FT Range
• 1P55 Water-resistant
• LED Indicator
• 58 Tunes
• Touch Button
• Memory function
• Frequency: 433 MHz
• Volume: 4 Levels
• Reciever: 110-240V
• Wattage: <0.5W
• Transmitter: <10mW
• 1 CR2032 battery (included)
• FCC ID: 2AANZWDOR

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired operation.

Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>