CONNECTPRO FL070 FestoonPro 2m Black Starter Cable User Manual

Table of Contents

Warnings

For decorative purposes only. Keep out of reach from children and animals.
This product cannot be submerged in water and do not position this product near any source of direct heat.
If the starter cable is plugged outdoors, ensure the outdoor socket or junction box is fully waterproof.
If a product becomes damaged, it must be disposed of accordingly. LED bulbs cannot be replaced.
Always consult Festive Light Ltd for technical advice. Keep this information sheet for future reference.
If you are installing a large display, we recommend using a weather repellent spray in all connections to reduce the likelihood of electrical trips and to eliminate human error. Q20 is available to purchase from Festive Lights Ltd.
For any technical information relating to this product, please email Festive Lights Ltd on contact@festive-lights.com. We aim to respond within 2 working days. Alternatively, contact our help line on (01257) 792111. This service is available between 9.00am – 5.00pm Monday to Friday.

In the interest of the safe and proper use of this product, please read these instructions carefully and retain them for future reference.

Part of our commercial quality 240V connectable system, this product is compatible with both the Festoon PRO & ConnectPRO connectable ranges.
When connecting multiple sets from this range, please ensure that the maximum wattage of 300W per power cable is not exceeded.
All products in this range come with weatherproof2 pin connectors, allowing seamless integration.
The lights and accessories are manufactured to IP65 and above and allow for indoor and outdoor use.
The dimmer controller is manufactured to IP65 standards. If connecting outdoors, please ensure the plug is connected to a weatherproof socket or Dribox which is available to purchase from Festive Lights Ltd.
Note : the lifespan of this system is subject to the way in which it is handled; make sure it is handled carefully during assembly, dismantling and storage. Dry thoroughly before storage, as damp can significantly shorten the lifespan.

Before you start

The warranty will be invalidated if any of the Festoon PRO or ConnectPRO range is powered by a generator or unregulated power source.
The warranty will be invalidated if any of the festoon Pro range is powered on the same circuit as any high powered electric appliance as this can damage the LEDs.
Check the product for any damage or defects before connecting to the electricity supply. Test products are working correctly (Festive Lights Ltd will not cover any costs related to pre and reinstallation).
The product MUST NOT BE MODIFIED; if any modification is made i.e. cutting/extending lead wires or using a different power source than supplied, warranty will be invalidated and may render the product unsafe.
Make sure you connect the power supply to a regular 240V socket, but do not switch on until all connections are complete.

How to operate with controller

When using the built-in controller, use the button on the left to activate the timer
Press the button once to turn the lights on.
Press twice and the button will illuminate green, indicating the 6 hour timer is on (6 hours on and 78 hours off).
Press three times and the button will illuminate red, indicating the 8hour timer is on (8 hours on and 76 hours off).
Press the button four times to turn the lights off.
Press and hold the button on the right to reduce/increase the brightness.

Please note : Lights may flicker on the low brightness settings when using the ConnectPRO light strings.

How to operate with the remote control

| CONNECTPRO FL070 FestoonPro 2m Black Starter Cable [pdf] User Manual
FL070 FestoonPro 2m Black Starter Cable, FL070, FestoonPro 2m Black Starter Cable, 2m Black Starter Cable, Starter Cable
---|---