DTC SOL8SDR-C Manet Radio Solutions User Guide
- June 12, 2024
- DTC
Table of Contents
DTC SOL8SDR-C Manet Radio Solutions User Guide
Overview
This quick start guide provides instructions and diagrams describing how to
quickly connect and configure the SOL8SDR-C device to join a Mesh network.
Note: If configuring as a SOL-TX or SOL-RX, please refer to the relevant
user guides. Supporting software applications and detailed user guides can be
downloaded from DTC’s WatchDox facility. Please contact the DTC support team.
Connections
The minimum connections required for an SDR-C to join a Mesh network are power
and antennas. An Ethernet connection to a PC is required for initial
configuration.
Note: The power source must be 8-18VDC.
Depending on how the SDR-C is to be deployed, a video source, audio headset,
or serial data connections may be attached for additional functionality.
Additionally, an optional amplifier integration can boost the power output,
thereby, increasing range. Please refer to the user guides for details.
_ Note: The cables in the image below are provided for illustration, a
full list of cable options can be found in the datasheet or user guide.
_
Initial Communications
DTC’s Node Finder application can be used to identify all DTC device Ethernet IP addresses connected on a network.
The default setting requires the device to be connected by Ethernet to a DHCP server which will automatically allocate an IP address. If a DHCP server is not available or the SDR is connected directly to a PC, the SDR and PC IPv4 address will need to be configured to be on the same subnet.
Right-click the SDR on Node Finder to reconfigure the IP settings as needed.
When the SDR IP address has been established, open a web browser, and enter it
in the address bar.
On authentication, leave the Username blank and enter the Password as
Eastwood.
Basic Mesh Setup
Mesh settings must be configured to join a network. In the web user interface
Presets>Mesh Settings page, the settings highlighted below must be the same
for all nodes in a network except the Node Id which should be unique. These
settings will depend on operational requirements.
When the SDR has been configured, the Ethernet connection to the PC can remain
if it is to be the control node for the Mesh network, otherwise, disconnect to
prevent network looping.
Copyright © 2023 Domo Tactical Communications (DTC) Limited. All rights reserved. Commercial in Confidence
Phone US: +1 571 563 7077
Phone UK: +44 1489 884 550
Email US:
us.technical.support@domotactical.com
(no restricted content)
Email ROW:
uk.technical.support@domotactical.com
(no restricted content)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>