MANROSE Hyper150 EC Bathroom Fan Owner’s Manual
- June 12, 2024
- MANROSE
Table of Contents
MANROSE Hyper150 EC Bathroom Fan
Product Information
The Designer Series Hyper150 EC Bathroom Fan (FAN7000) is designed specifically for healthy home standard bathrooms. It features switching/wiring options, including continuous slow extraction with manual boost and continuous control. The fan comes with a variable speed controller for adjustable noise level, exhaust speed, and energy efficiency. The Hyper150 EC Axial Fan is constructed with a die-cast aluminum impeller and outer housing made of PBT plastic. It has a sound level of 38 db(A) and an IP44 rating for protection against water splashes.
Product Usage Instructions
To use the Hyper150 EC Bathroom Fan, follow these instructions:
- For continuous slow extraction with manual boost, set the potentiometer on the variable speed controller to the desired slow continuous rate.
- Secure the speed controller in the ceiling space to prevent tampering.
- For optimal performance, ensure proper ducting system selection and installation best practices are employed.
- Refer to the Instruction Manual for detailed installation instructions.
- Compliance with the building code remains the responsibility of the installer and depends on how the duct and accessories are installed.
Note: The Hyper150 EC Axial Fan with Variable Speed Controller is suitable for bathrooms with less complex duct runs at full speed. Refer to the provided chart for guidance on fan selection based on bathroom dimensions, number of bends, and meters of ducting.
FEATURES
- Latest EC fan technology
- Continuously-variable speed controllable
- Environmentally friendly with at least 33% less energy used at just 18W
- Long life with lower operating temperature brushless technology
- Euro flush-box for variable speed control switch included
Hyper150 EC Axial Fan with Variable Speed Controller FAN7000
Specifications
FAN7000 Technical Specifications – at Full Speed
- Supply 110-240V AC 18W 50Hz
- Maximum Pressure 91 Pa
- Max. Free-Air Performance 105 l/s, 380m3/hr
- Specific Fan Power 0.17 W/l/s
- Fan Construction Die cast aluminum
- Impeller & Outer Housing PBT plastic
- Maximum Operating Temp 45ºC
- Sound Level 38 db(A)
- IP Rating IP44
Performance
Performance Curve – Full Speed
Bathroom Applications
Fan Selection for Bathroom Applications
Hyper150 EC axial inline fan with variable speed controller is designed to
meet New Zealand Building Code G4/AS1 and is suitable for bathrooms with less
complex duct runs at full speed. The following chart provides a quick
reference guide for Hyper150 EC axial inline fan with variable speed
controller as being the right choice based on good ducting system selection
and installation best practices being employed. Installation details in the
Instruction Manual must be followed. Compliance with the building code remains
the responsibility of the installer as it is dependent on how the duct and
accessories are installed.
Bathroom
Options
3 Switching/Wiring Options
- OFF/ON switching for fitting to European flush box DCT4411 included
- 10m long control cable
- 3-pin plug with lead
OPTIONAL NZ/AUS Wall Switch
for continuous trickle extraction and full-speed boost via fan switch
Continuous Slow Extraction with Manual Boost Set the potentiometer at slow continuous rate and secure the speed controller from tampering in ceiling space
Dimensions
Dimensions (mm)
CONTACT
- PO Box 14347, Panmure, Auckland 1741, New Zealand
- p +9 259 1660
- sales@simx.co.nz.
- w www.manrose.co.nz.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>