DYNASTY D76F6A73 Rear Outlet Toilet Instruction Manual

DYNASTY D76F6A73 Rear Outlet Toilet

BEFORE INSTALLING

Read entire Rear Outlet Toilet Installation Instructions. Observe all local building and safety codes.

INSTRUCTIONS

For the following installation instructions for a new toilet, it is assumed that all old fixtures have been removed and the toilet flange is in the new toilet. Unpack and inspect the product for any shipping damage. Do not install if found damaged. Please contact customer service. If you need help or have questions about installing your toilet, please contact Customer Service.

If you are new to bathroom fixture installation, we recommend that you consult a professional. We are not responsible for any damage to floors, walls, pipes or personal injury during installation.

TOOLS AND MATERIALS

• Pencil
  

• Hacksaw

• Level

• Drill

• Adjustable Wrench

• PVC Glue

INSTALLATION

1. If you are installing a two-piece toilet, slide thank bolts through the mounting holes on the top of the base of the toilet and thread the washers and nuts onto the tank bolts. Verify that the tank is level and alternately tighten washers and nuts until the tank is resting firmly on bowl. If your toilet is one piece only, move on to the next step.

2. Place the toilet in the location where it will be installed.

3. Measure the distance from the back of the waste outlet on the toilet to the wall hub fitting to determine the length of the p-trap connector. The connector should extend approximately 1- 1/2″into the hub fitting.

4. Trim the p-trap adapter with a hacksaw to the appropriate length as necessary.

5. Mark the location of the pre-drilled mounting holes using the holes in the base of the toilet as a template.

6. Remove the toilet from the work area and drill mounting holes in the locations designated in the previous step.

7. Apply PVC or ABS glue around the p-trap connector and place inside the hub fitting.

8. Slide the toilet into place and press the waste outlet into the p-trap connector.
   

9. Once the toilet is securely in place, insert anchor bolts and washers through the mounting holes in the base of the toilet and tighten into the pre-drilled holes created in step 6.

10. Place caps over the anchor bolts on the base of the toilet.
    

11. Connect the water supply tubes at the bottom of the tank. Turn on the water supply and flush the toilet several times to check for any leaks around the back or base.
    

12. Attach the toilet seat.

13. Finish your installation by applying latex caulk tile grout around the base of the toilet. This will finish the joint between your floor and toilet bowland divert water away from the base of the toilet.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>