RALPH LAUREN RL 5081 Allen Small Pendant User Guide
- June 4, 2024
- ralph lauren
Table of Contents
ASSEMBLY INSTRUCTIONS
RL 5081 Allen Small Pendant
TO assemble safety cables:
- Join fixture safety cables with safety cable from ceiling.
- Wrap both safety cable around the cable lock nut.
- Insert screws into both holes on cable lock nut, and secure screws with screwdriver.
- Push the cable lock nut into outlet box.
Allen Small Pendant
Item # RL 5081
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
-
Carefully remove all parts from the box.
-
Thread tube (H) to the fixture body (I), then thread the tube (G) to tube (H).
-
Let the canopy (E) and lock collar (F) pass through the tube (G).
-
Install the mounting plate (B) to the outlet box by mounting screws (C) provided.
-
Attach fixture body to the mounting plate (B) and seucre with screw (D) by using the wrench.
-
Measure the wires and cut. Be certain to leave enough to connect inside of the canopy.
-
Connect the fixture ground (bare) wire with the ground wire from the outlet box using wire nut (A). If your house does not have ground wire, then attach this wire to the green grounding screw inside of the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED. -
Connect the fixture Neutral wire (ribbed, no markings) with the neutral wire from the outlet box using wire nut (A).
-
Connect the fixture Hot (smooth edge, markings) wire with the hot wire from the outlet box using wire nut (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED. -
Tuck these wire connections neatly into the outlet box to secure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>