Belife C1CjT71SD9L Cordless Vacuum Cleaner User Manual

Belife C1CjT71SD9L Cordless Vacuum Cleaner

Assembly as shown below

Align the main body, extension rod and the cleaning tool as shown and insert until they “click”. To remove any attachments/ accessories, press and hold the button, and pull to remove.

NOTE: All attachment included are compatible with the main body and the extension rod.

Insert battery

Slide in the slot rail to load the battery.

Turn on the vacuum cleaner

1. Pull the ON/OFF trigger to turn on.

2. Pull the same trigger to turn off.

Troubleshooting

Digital Display Panel

• Remove hair and foreign objects from the brush. Remove compressed hair strains from the bearing. Refer to the maintence section in our instruction manual.
• Check and remove any foreign object in the floor brush, extension rod, main body air inlet and dirt bin.
• Please follow instructions on page 3-4 to clean up and keep the HEPA filters free from blockage.

| Brush stuck|

• Remove any foreign objects that cause the brush to cut off power automatically.
• if none foreign object is found(it may have dropped off), restart the vacuum.

| Voltage problem|

• This problem is caused by defective battery. Please contact our customer service for battery replacement.

| The screen not light up after a few seconds when fully charged|

• This problem is caused by defective battery. Please contact our customer service for battery replacement.

NOTE: If you have any other questions, please contact us and we will solve them for you.

Mode suggested

| Eco Mode|

• 40min runtime, Suitable for hair and dust on wood floor or tile.

---|---|---
| Normal Mode|

• 30min runtime, Suitable for fine dust and hair on low pile carpet.

| Hyper Mode|

• 10-15min runtime, Suitable for dog food, coffee beans and other large particles on low pile carpet.

One Click Empty

Cleaning frequency: After every use.

1. Pull the pull ring gently to damp trash in the dust cup.

Cleaning the cyclone unit

Cleaning frequency: Whenever needed.

1. Pull the pull ring fully

2. Lift the dirt bin

3. Remove the dirt bin

4. Gently pull to separate the cyclone unit from the dirt bin

5. Brush cyclone unit to remove debris and dust

WARNING! Never attempt to disassemble the sealed cyclone unit.

Cleaning the HEPA filter

Cleaning frequency: 3-6 months or whenever airflow is weak.

1. Turn the HEPA filter counter-clockwise to remove

2. Wash with tape water

3. Dry completely

Cleaning the pre-motor filter

Cleaning frequency:1-2 months or whenever airflow is weak.

1. Remove HEPA filter first, then gently pull out the pre-motor filter

2. Wash with tape water, hand wash with soap if necessary

3. Dry completely

WARNING!

1. DO NOT brush any part of the porous filtration material.
2. DO NOT soak any filter in water for more than 10 minutes.
3. DO NOT wash any other part of the vacuum except the spcecified filters assembly

Cleaning the brush and bearing

1. Pull to release brush locking clip

2. Remove the brush locking clip

3. Lift the roller from clip end

4. Remove debris on two small brush wheels with tweezers

5. Gently pull to remove the brush bearing cap

6. Remove debris on the shaft

7. Apply lubricating oil or “WD40” onto the metal bearing occasionally

Contact us if you have any questions:

Belifehome@outlook.com
401-300-0032
9AM-5PM (CDT) WEEKDAY

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>