MeTra 99-6515 Single DIN Dash Kit Installation Guide

: June 12, 2024
: Metra

Table of Contents

MeTra 99-6515 Single DIN Dash Kit
KIT FEATURES
KIT COMPONENTS
TOOLS REQUIRED
DASH DISASSEMBLY
KIT PREPARATION
KIT ASSEMBLY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MeTra 99-6515 Single DIN Dash Kit

KIT FEATURES

DIN radio provision with pocket
ISO DIN radio provision with pocket
Painted in two different colors:
99-6515B = Black
99-6515W = White

KIT COMPONENTS

A: Radio housing
B: ISO brackets
C: ISO trim panel

MeTra-99-6515-Single-DIN-Dash-Kit-fig-2

WIRING & ANTENNA CONNECTIONS (sold separately) Wiring Harness: XSVI-6515-NAV Antenna Adapter: 40-EU55 Steering Wheel Control Interface: ASWC-1

TOOLS REQUIRED

Panel removal tool
Phillips screwdriver
10mm socket wrench
Radio removal keys (Metra part number 86-5618)

CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running.

DASH DISASSEMBLY

Remove the covers from the (4) “radio removal tool holes” in the factory radio. (Figure A)
Using Metra’s 86-5618 radio removal tools, pull the factory radio from the dash. (Figure B)
Remove (1) 10mm bolt from the center rear of the metal radio support and (2) Phillips screws from both sides of the support then remove it from the sub dash. (Figure C) Continue to Kit Preparation

KIT PREPARATION

Trim the area at the bottom of the sub dash opening to allow for clearance of the radio housing. (Figure A)
Secure the radio housing to the sub dash with the factory hardware. (Figure B)

KIT ASSEMBLY

DIN radio provision with pocket

Remove the metal DIN sleeve from the aftermarket radio.
Slide the sleeve into the radio housing and secure by bending the metal locking tabs down. (Figure A)
Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Test the radio for proper operation.
Slide the radio back into the sleeve until it clicks in. (Figure B)

ISO DIN radio provision with pocket

Remove the metal DIN sleeve and trim ring from the aftermarket radio.
Secure the ISO brackets to the radio with the screws supplied with the radio. (Figure A)
Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Test the radio for proper operation.
Slide the radio into the radio opening until the side clips engage. (Figure B)
Snap the ISO trim panel into the radio housing. (Figure C)

IMPORTANT
If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more inform