JENNAIR JKRPR151HM Ice Maker RISE Stainless Steel Panel Accessory Instruction Manual
- June 12, 2024
- JENNAIR
Table of Contents
INSTALLATION INSTRUCTIONS
for Jenn Air® Ice Maker RISE™ Stainless Steel Panel Accessory
Use the materials in this accessory kit to install the RISE™ stainless steel panel by following the installation instructions.
JKRPR151HM Ice Maker RISE Stainless Steel Panel Accessory
Before you begin:
A qualified service technician must perform installation.
Panel Accessory contains:
- Front Panel and Handle Assembly
- Screws (2)— #8-15 X .813 HW A
Tools required:
- Phillips Screwdriver
- Flat Head Screwdriver
- Diagonal Cutting Plier
Installation Procedure
- Remove the screws attaching hinge covers using the flat head screwdriver.
- Remove the hinge cover from upper and lower hinges.
- To remove, cut hinge cover at indicated point using diagonal cutting plier and remove from hinges.
- Remove screws (3) from the top and bottom metal brackets using the Phillips screwdriver. Remove and discard metal brackets and holding screws.
- Slide new front panel assembly on the Ice Maker door from the top.
- Use #8-15 X .813 HW A screws (2) with the Phillips screwdriver to fix mount the front panel assembly.
- Refer Installation Instruction supplied with unit for final installation.
W11290039A
®/™ ©2018 Jenn Air. All rights reserved.
Used under license in Canada.
Documents / Resources
|
JENNAIR JKRPR151HM Ice Maker RISE Stainless Steel Panel
Accessory
[pdf] Instruction Manual
JKRPR151HM, JKRPR151HM Ice Maker RISE Stainless Steel Panel Accessory, Ice
Maker RISE Stainless Steel Panel Accessory
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>