HANYOUNG nuX TF62N Analog Timer Instruction Manual

Table of Contents

Alerts declared in the manual are classified to Danger, Warning and Caution by their criticality

DANGER indicates an imminently hazardous situation which, it not avoided, will result in death or serious injury
WARNING indicates a potentially hazardous situation which, it not avoided, could result in death or serious injury
CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury

Danger
Do not touch or connect any undesirable conductive part to input cutout terminal since there is a possibility of electric shock.

Warning

Please install an appropriate protective circuit on the outside if malfunction, an incorrect operation or tailored of the product may be a cause of leading to a serious accident and plan for preventing accidents,
After mounting the product onto a panel, please use a socket dedicated to the product when connecting with other units and do not turn on the power until completing wiring to prevent electric shock.
Please turn off the power when mounting/dismounting of the product. This is a cause of electric shock, malfunction, or failure.
If the product is used with methods other than specified by the manufacturer, then it may lead to injury or property damage.
In order to use this product properly and safely, we recommend periodic maintenance.
The warranty of this product (including accessories) is 1 year only when it is used for the purpose it was intended under normal condition.

Caution

Please do not set “Time to ‘0*. This can be a cause of malfunction, Also, there could be a time difference in timer operation, Please use it after confirming the time difference. Please set or change “Time Range in the dip switch while the timer is OFF. If the Time Range” has been changed to another value during the operation, please turn off the timer and turn it back on.
Since this is not an explosion-proof structure, please use in a place where corrosive gas (such as harmful gas, ammonia, etc.), combustible or explosive gas does not occur.
Please use in a place where there is no direct vibration and a large physical impact to the product.
Please use in a place where there is no water, oil, chemicals, steam, dust, salt, iron or others
Please avoid using in a place where excessive amounts of inductive interference or electrostatic and magnetic noise occur.
Please avoid using in a place where heat accumulation occurs due to direct sunlight or radiant heat,
Please use in a place where the elevation is below 2.000 m.
Please make sure to inspect the product it is exposed to water since there is a possibility of electric leakage or a risk of fire.
If there is a lot of noise from the power line, installing an insulated transformer or a noise filter is recommended.
When the power is being supplied there should be a preparation time for the contact output. Please use a delay relay together when it is used as a signal on the outside of interlock circuit or others.