BE AG INDUSTRIAL 21.100.006 Professional Series Pistol Grip Grease Gun Instruction Manual

PROFESSIONAL SERIES
PISTOL GRIP GREASE GUN
OPERATING INSTRUCTIONS MANUAL

OPERATING INSTRUCTIONS

14 OZ. GREASE GUN LOADING

1. Pull plunger back & lock in place. This helps seal the unit to prevent leakage and contamination.
2. Remove grease gun head, remove plastic cap from cartridge, and insert face down into gun.
3. With cartridge inserted, removed pull tab / flip top from exposed end of cartridge, and replace the grease gun head.
4. Release the plunger lock, and pump lever handle several times to prime grease gun.

**Air bleeder valves help remove air pockets from inside of cartridge, and assist in priming the gun easier.

BULK LOADING

1. Remove or replace the plug or air bleeder valve with a bulk loader fitting that fits the bulk loader coupler.
2. Couple the bulk load coupler to the fitting securely by pushing in and rotating slightly.
3. Holding the grease gun firmly and securely in place, pump the barrel pump and watch as the plunger rod extends out. When the groove in the rod becomes visible, the gun is full.
4. Rotate the coupler back off of the bulk loader fitting to release the gun from the pump, and push the plunger rod back into the gun to start using.

**Do not pump beyond the indicator groove, as grease may push past the plunger seal.

SUCTION FILLING

1. Remove grease gun head, and submerge the open end into the bucket of grease.
2. Hold the gun firmly and securely, and slowly draw the plunger back to fill the gun.
3. Watch for the groove in the plunger rod to indicate the gun is full, and then lock the plunger rod in place.
4. Replace the grease gun head back onto the gun and release the plunger lock.

**Always keep the open end of the barrel submerged while drawing on the plunger to ensure no air gets sucked into the gun.

WARRANTY INFORMATION

TWO YEARS LIMITED WARRANTY
For a period of two (2) years from your purchase date, BE AG & INDUSTRIAL will repair or replace (at its option) without charge, your BE AG & INDUSTRIAL product if it was purchased new and the product has failed due to a defect in material or workmanship which you experienced during normal use of the product. This limited warranty is your exclusive remedy.
If this BE AG & INDUSTRIAL product is altered, abused, misused, modified, or undergoes service by an unauthorized technician, your warranty will be void. We are not responsible for damage to ornamental designs you place on this BE AG & INDUSTRIAL product and such ornamentation should not cover any warnings or instructions or they may void the warranty.
This warranty does not cover scratches, superficial dents, and other abrasions to the paint finish that occur under normal use.
To access the benefits of this warranty, contact the dealer or retailer where the unit was purchased. For further assistance, you can contact BE AG & INDUSTRIAL at warranty@brabereq.com for confirmation that this warranty applies. Thereafter, you may be
advised to return the product under warranty, freight prepaid, to the dealer or directly to the BE AG & INDUSTRIAL service department.
Subject to the law in your state:

1. Your sole and exclusive remedy is repair or replacement of the defective product as described above.
2. BE AG & INDUSTRIAL is not liable for any incidental damages, including but not limited to, lost profits and unforeseeable consequences.
3. The repair and replacement of this product under the express limited warranty described above is your exclusive remedy and is provided in lieu of all other warranties, express or implied. All other warranties, including implied warranties and warranties of
   merchantability or fitness for a particular purpose are disclaimed and, if disclaimer is prohibited, these warranties are limited to two years from your date of purchase of this product.

PARTS@BRABEREQ.COM
TOLL FREE PHONE
FRAIS: 1-877-588-3311

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>