BE AG INDUSTRIAL 21.200.004 Lever Action Grease Gun Instruction Manual
- June 13, 2024
- BE AG INDUSTRIAL
Table of Contents
LEVER ACTION
GREASE GUN
21.200.004 Lever Action Grease Gun
OPERATING INSTRUCTIONS MANUAL
| MODEL NO. | TYPE | CAPACITY | HOSE | PIPE |
|---|---|---|---|---|
| 21.200.004 | LEVER ACTION | 14 OZ 395 G | 9” 228MM | 6” 150MM |
OPERATING INSTRUCTIONS
14 OZ. GREASE GUN LOADING
-
Pull plunger back & lock in place. This helps seal the unit to prevent leakage and contamination.
-
Remove grease gun head, remove plastic cap from cartridge, and insert face down into gun.
-
With cartridge inserted, removed pull tab / flip top from exposed end of cartridge, and replace the grease gun head.
-
Release the plunger lock, and pump lever handle several times to prime grease gun.
Air bleeder valves help remove air pockets from inside of cartridge, and
assist in priming the gun easier.
SUCTION FILLING**
-
Remove grease gun head, and submerge the open end into the bucket of grease.
-
Hold the gun firmly and securely, and slowly draw the plunger back to fill the gun.
-
Watch for the groove in the plunger rod to indicate the gun is full, and then lock the plunger rod in place.
-
Replace the grease gun head back onto the gun and release the plunger lock.
**Always keep the open end of the barrel submerged while drawing on the plunger to ensure no air gets sucked into the
WARRANTY INFORMATION
ONE YEAR LIMITED WARRANTY
For a period of one year from your purchase date, BE AG & INDUSTRIAL will
repair or replace (at its option) without charge, your BE AG & INDUSTRIAL
product if it was purchased new and the product has failed due to a defect in
material or workmanship which you experienced during normal use of the
product. This limited warranty is your exclusive remedy.
If this BE AG & INDUSTRIAL product is altered, abused, misused, modified, or
undergoes service by an unauthorized technician, your warranty will be void.
We are not responsible for damage to ornamental designs you place on this BE
AG & INDUSTRIAL product and such ornamentation should not cover any warnings
or instructions or they may void the warranty.
This warranty does not cover scratches, superficial dents, and other abrasions
to the paint finish that occur under normal use.
To access the benefits of this warranty, contact the dealer or retailer where
the unit was purchased. For further assistance, you can contact BE AG &
INDUSTRIAL at warranty@brabereq.com for
confirmation that this warranty applies. Thereafter, you may be advised to
return the product under warranty, freight prepaid, to the dealer or directly
to the BE AG & INDUSTRIAL service department.
Subject to the law in your state:
- Your sole and exclusive remedy is repair or replacement of the defective product as described above.
- BE AG & INDUSTRIAL is not liable for any incidental damages, including but not limited to, lost profits and unforeseeable consequences.
- The repair and replacement of this product under the express limited warranty described above is your exclusive remedy and is provided in lieu of all other warranties, express or implied. All other warranties, including implied warranties and warranties of merchantability or fitness for a particular purpose are disclaimed and, if disclaimer is prohibited, these warranties are limited to one year from your date of purchase of this product.
PARTS@BRABEREQ.COM
TOLL FREE PHONE
FRAIS: 1-877-588-3311