Dektite DNLS10MB Multicable Solar Flashing Instruction Manual
- June 12, 2024
- Dektite
Table of Contents
A Skellerup Industries Company
DNLS10MB Multicable Solar Flashing
Instruction Manual
Installation Instructions
Fit the acrylic lead apron in the same way as a conventional lead weathering
slate. The area where the tiles or slates have been cut or moved should be
completely covered. It will normally be inserted under the tiles or slates
above the penetration and dressed over the adjoining tiles or slates as shown
below. 
The cables should be
passed through the flashing as follows:
- Check exact outside diameter of the cables.
- Cut the nipples as indicated for 4-6mm or 6-8mm cables. Use tin snips or scissors ensuring that the cut is straight and parallel to give a tight fit to the cable. DO NOT pierce the cable nipple with a craft knife or other pointed implement.
- Pass cables through using water as a lubricant if needed.
Product code| Cable Diameter| Base size| Roof pitch|
Material
---|---|---|---|---
DNLS10MB| 4-8mm| 490 x 410mm| 0-45°| EPDM/lead base
SDA10MB| 4-8mm| 490 x 410mm| 0-45°| EPDM/aluminium base
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>