CLSV-LXKS Vax Evolve Cordless Vacuum User Guide

Cordless Vacuum
USER GUIDE
CLSV-LXKS
CLSV-LXBS

SAFETY GUIDE

This machine is intended for household use only and NOT for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE AND USE ONLY AS INSTRUCTED IN THIS GUIDE.
The full user guide can be found at: support.vax.co.uk
DON’TS

• Don’t leave the charger plugged in when unattended.
• Don’t use the machine if it is faulty or has been dropped, damaged or left outdoors.
• Don’t use the machine to pick up any flammable or combustible materials (lighter fluid, petrol, kerosene etc.) or use the machine in an area with explosive vapours or liquid.
• Don’t use the machine to pick up hot coals, cigarette butts, matches or smoking hot burning items or use in an area where there may be harmful fluids (chlorine, bleach and ammonia drain cleaner).
• Don’t handle the charger, battery or use the machine with wet hands.
• Don’t unplug the charger by pulling on the power cord.
• The power cord cannot be replaced. If the cord is damaged the charger should be scrapped.
• Don’t attempt to remove blockages with sharp objects as this may cause damage to the machine.
• Don’t use the machine with the incorrect battery or charger as this may result in damage or injury to the user. The correct battery charger information is listed on the battery pack ratings label.
• Don’t charge the battery outdoors, or leave the charger connected to the mains when not in use.
• Don’t use the machine with a damaged battery. If the battery is damaged contact us on: 08000 927737
• Don’t use on a surface that is damaged, uneven or incorrectly fitted.
• The brush bar constantly rotates in carpet and hard floor mode. Never use on one spot for any prolonged period of time as this may damage the floor surface.
• Don’t use the machine on stairs.

DO’S

• Only VAX ONEPWR batteries (BVXXXXX) and chargers (BV05XXX) should be used with this machine.
• Always stand the charger on a stable, level surface, uncovered and away from any heat source.
• Always remove the battery from the machine before carrying out any maintenance or if storing unused for a long period of time.
• Keep all openings clear, free from debris and don’t overfill the dirt container as this may affect the airflow/suction.
• Turn off all controls on the machine before disconnecting or connecting the battery.
• This machine is not intended to be used or cleaned by persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given instructions concerning the safe use of the  machine by a person legally responsible for their safety. They should be supervised whilst using the machine. Children shall not use, clean or play with this machine, which when not in use should be secured out of their reach.
• Only use the machine indoors on dry surfaces and keep the area you’re cleaning well lit.
• Always use the correct mode for your flooring and check the suitability with the flooring manufacture before use. To prevent any damage being sustained, test on a inconspicuous area of the flooring/surface first.
• Always make sure the separator and filter are fitted correctly before using your machine and only use the machine with the filter and separator in place.
• Always check that the floorhead and brushbar are free from damage, dirt and debris before using.
• Keep fingers, hair and loose clothing away from moving parts and openings whilst using the machine.
• Store the machine in a cool, dry area. Keep the machine away from rain and moisture.
• Use only CE approved 13amp extension cords, non-approved extension cords may overheat. Care should be taken to arrange the extension cord as it can be a trip hazard.

BATTERY SAFETY PRECAUTIONS

• Replace the battery with a VAX ONEPWR battery only. Use of another battery may present a risk of fire or explosion.
• Don’t attempt to disassemble the battery, remove any component projecting from the battery terminals and do not dispose of in a fire. The battery and charger have no user serviceable parts. Fire or injury may result.
• Prior to disposal, protect exposed terminals with heavy insulating tape to prevent shorting. The battery is to be disposed of safely at your local battery recycling centre.
• When the battery pack is not in use, keep it away from other metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.
• In case of battery leakages, avoid any contact with skin and contact us on: 08000 927737

Welcome to the VAX family!

You are now the proud owner of a VAX Evolve.
Here, you’ll find everything you need to know about your machine and, most importantly, instructions on how to get started so that you can get cleaning !

Weight 3.2kg (without battery pack). Dirt bin capacity 1.2L.
Runtime and charge time dependent on battery pack and mode used. *Included with model CLSV-LXKS only.
Subject to technical change without notice. Images are illustrative only.

Quick Start

Assembly
Attach the handle to the main body of the machine until it clicks into place

Charging the battery
Charge the battery for 3 hours before use*

Operation
Switch on the machine and select a mode HARD FLOOR CARPET BRUSH OFF
For delicate floors and flooring not suitable for use with a rotating brush bar

Registration & Support

All ONEPWR products come with a standard one year warranty
Register your product to receive 2 YEARS FREE additional warranty†
For details visit: vax.co.uk/registration
Scan here

https://support.vax.co.uk/

For help and support with your new product or visit us online:support.vax.co.uk
Still need to get in touch?
Our UK based Customer Care Team are here to support you. For help with assembly, operational or performance problems, or buying and fitting new accessories, you can find all our contact details at vax.co.uk/contact
This user guide can be found online at: support.vax.co.uk
† Registration required. Terms and conditions apply, see vax.co.uk for details.

WARRANTY & TECHNICAL

WARRANTY
If a VAX ONEPWR machine is used in the way it is intended and it breaks down within the guarantee period, it’s our responsibility to repair or replace it.
Here’s what isn’t covered:

• Normal wear and tear of consumable items, for example: belts, filters, brushrolls, fuses etc.

• Batteries which have become faulty as a result of improper handling.

• Batteries which have a reduced service life as a result of normal wear.

• Accidental damage
  – Damage as a result of use not in accordance with the product user guide.
  – Damage caused by not carrying out regular maintenance.
  – Damage to the charger cable.
  – Blockages caused by misuse.

• Faults caused by:
  – Negligent use, misuse, neglect or careless operation of the machine.
  – Use of the machine cleaner which is not in accordance with the user guide.
  – Use of a VAX ONEPWR machine for anything other than normal domestic household purposes in the country in which it was purchased.
  – Use of parts, accessories and consumables, which are not genuine VAX components.
  – Faulty installation or repairs – unless carried out by a qualified electrician or engineer.

TECHNICAL
Statement of Compliance: Manufacturer/EU importer: VAX Limited, hereby on our own responsibility, declare that the VAX Evolve is manufactured in compliance
with the following Legislation:
Safety: 2014/35/EU Low Voltage Directives/Electrical Equipment (Safety)
Regulations 2016. EMC: 2014/30/EU Electromagnetic Compatibility Directive/
Electromagnetic Compatibility Regulations 2016.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.
VAX is a trade mark of Techtronic Cordless GP.
© 2021 Techtronic Cordless GP. All rights reserved.
VAX Ltd, Artillery House, Heritage Way, Droitwich, WR9 8YB, UK.

GETTING STARTED

CHARGING THE BATTERY
THIS MACHINE IS ONLY TO BE USED WITH VAX ONEPWR BATTERIES AND CHARGER.
PLEASE READ THE SAFETY GUIDE BEFORE USE.
NOTE: Before first use, ensure the battery is fully charged. Failure to fully charge the battery before first use may result in poor battery performance. The life expectancy of the battery will vary depending on the usage of the machine.

Slide the battery down on to the charger
until it clicks into place.| The charger light will flash white to
show when the battery is charging.
The light on the charger will stop
flashing and go off when the battery
is fully charged.| Once fully charged, slide the battery off
the charger to remove.
To check the battery charge
level press the battery symbol.

ASSEMBLY

Push the handle into the main body until it clicks into place.

OPERATION
WARNING: The brushbar constantly rotates in carpet and hard floor mode.
Never use on one spot for any prolonged period of time as this may damage the floor surface.
To prevent any damage being sustained test on an inconspicuous area of the flooring first.

Slide the battery onto the machine until
it clicks into place.| Place your foot on the floorhead.| Pull the handle backwards to recline.

Press the on/off button to switch the machine on.| Press the mode selector button to switch between modes.| To remove the battery press both the buttons to release.

HARD FLOOR
CARPET
BRUSH OFF
For delicate floors and flooring not suitable for use with a rotating brush bar.

CLEANING & MAINTENANCE

WARNING: Always remove the battery before carrying out any maintenance or troubleshooting.
EMPTYING THE DIRT CONTAINER
CAUTION: Don’t over fill the dirt container to avoid blocking the air flow through the machine.
For best cleaning results, empty the dirt container after every use. Filters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed every 3 months. Filters should be replaced every 6-9 months depending on the level of use.

Press down the dirt container
release button and pull the container
to remove.| Hold the dirt container over a bin and
press the dirt release button to allow dirt
and debris to fall out. To close, push the
dirt release door until it clicks into place.| To re-fit, tilt the dirt container and line the
front of the container up onto machine.
Push back until it clicks into place.

CLEANING THE FILTER AND SEPARATOR

Press down the dirt container release
button and pull the container to remove.| Press the button on the lid of the dirt
container and lift the lid to access the
filter. Pull the tab on the filter to remove.| Lift the separator from the dirt container.

Tap the filter and separator against a
bin to remove dirt and debris.
Wipe over the separator metal shroud
with a dry cloth.| Wash the filter under running water
(40°C max). Leave for at least 24hrs or
until fully dry before replacing.|

REMOVING AND CLEANING THE BRUSHBAR
WARNING: Always remove the battery before carrying out any maintenance or troubleshooting.
CAUTION: If the brush bar has been obstructed, the brush bar motor protection sensor may activate and the brush bar will stop. To reset clear any obstruction and wait 1 minute before switching the machine on. For best performance and to reduce hair/dirt build up, remove and clean the brush bars every 1-2 months (depending on the level of use).

Lie the machine on its back.| Turn the tab on the brush bar cover
anticlockwise to release the brush bar.| Pull the brush bar out from the housing.

To remove any threads or hair, slide the
blade of a pair of scissors into the groove
on the brush bar and cut along the groove.| Clear any dirt/debris from the end caps
and inside the housing of the floorhead.| Refit the brush bar into the floorhead.

Align the arrow on the brush bar cover to the unlock symbol. Push firmly and twist the tab clockwise so the arrow is pointing to the lock symbol.

CHECKING FOR BLOCKAGES

Press down the dirt container release button and pull the container to remove.| Place your foot on the floorhead. Pull the handle backwards to recline and lie flat.

Press the hose release button and pull to release.| Check for any blockages and use a blunt object to remove the blockage.

TROUBLESHOOTING

THERE IS AN ACCESSORY MISSING
Check the contents on the box.
WHY DOES THE MACHINE HAVE NO POWER?

• The battery is not fitted correctly. See OPERATION page 7.

• The battery has no charge. See CHARGING THE BATTERY page 6.

• The motor thermostat may have tripped. Empty the dirt container and check for blockages.
  Clean the filters and allow the machine to cool for approximately 1 hour. If you have washed the filters, wait 24 hours to fully dry before placing back on the machine.
  See CLEANING THE FILTER AND SEPARATOR page 9.

• The brushbar motor sensor has been activated. To reset clear any obstruction, wait 1 minute before switching the machine on. See REMOVING AND CLEANING THE BRUSHBAR page 10 and OPERATION page 7.

WHY WON’T THE MACHINE PICK UP?

• The dirt container may not be correctly fitted. See EMPTYING THE DIRT CONTAINER page 8.

• The dirt container may be blocked. Check the dirt container for blockages.
  See EMPTYING THE DIRT CONTAINER page 8.

• The filters may be clogged or need replacing. See CLEANING THE FILTER AND SEPARATOR page 9.

• There maybe a blockage. See CHECKING FOR BLOCKAGES page 12.

• The brushbar has not been activated. See OPERATION page 7.

WHY WON’T THE BRUSHBAR ON THE FLOORHEAD TURN?

• The brush bar has not been activated. Go to OPERATION page 7.
• The brush bar may be obstructed. See REMOVING AND CLEANING THE BRUSHBAR page 10.

For how-to videos and
warranty registration visit
www.vax.co.uk
info@vax.co.uk vax.co.uk
VAX Ltd, Artillery House, Heritage Way, Droitwich, WR9 8YB, UK.

References

• Vax UK - Spares Support
• VAX Vacuum, Carpet & Steam Cleaners | VAX UK Official Website
• Contact VAX Ltd UK Customer Support Team | VAX.co.uk
• VAX Guarantee - Register Your VAX Machine | VAX.co.uk
• VAX Vacuum, Carpet & Steam Cleaners | VAX UK Official Website

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>