NT200E OBDII-EOBD Code Reader User Guide
- June 12, 2024
- NT200E
Table of Contents
NT200E OBDII-EOBD Code Reader
Updating
*No Registration Required/ PC: Windows 7, Windows 8 and Windows 10 supported.
Updating
- Download the update tool NT_WONDER and install
- Enable NT_WONDER and connect NT20 0E/NT200C to the computer with USB cable.:
- Click
or to start updating according to the software version conditions. - An Update Finished Message displays when the update is completed.
OVERVIEW
Shanzhen Foxwell Technology co., Ltd.
Pictures illustrated here are for reference only and this Quick start Guide is subject to change without prior notice, for more details, please refer to the user’s Manual.
NT200E/NT200C 080 II /EO8D CODE READER
The NT200E/NT200C CAN OBDII/EOBD Code Reader is an innovative and affordable solution specially designed for DIYers to get easy and quick access to engine problems on all OBDII compliant vehicles sold worldwide since 1996.
Applicable Functions
Read Codes / Freeze Frame Data
On-board Monitor Test/ Component Test
Erase Codes I Live Data
Vehicle Information I Modules Present
I/M Readiness / 02 Sensor Test
Unit of measure I DTC GUIDE
How to use NT200E/NT200C?
Before start diagnosis, please make sure :
- The ignition switch is turned to ON position.
- The engine is off.
- The vehicle battery voltage is between 10-14 volts.
- The scanner is connected to the vehicle correctly.
Don’t connect or disconnect the equipment while the ignition is on or the
engine is running.
OBD-11 Connector and Pinout
- Vendor Option/
- SAEJ1850BUS+
- Vendor Option/
- Chassis Ground/
- Signal Ground I
- CAN High(ISO 15765-4) I
- K-line of ISO 9141-2 and ISO 14230-4 / 8
- Vendor Option /
- Vendor Option /
- SAE Jl 850BUS- /
- Vendor Option /
- Vendor Option /
- Vendor Option/
- CAN Low(ISO 15765-4) /
- L-line of ISO 9141-2 and ISO 14230-4 /
- Battery Power
OBD Service Modes
*Mode 1* : Real-time data, MIL, IM monitors.
Mode 2 : Freeze frame.
Mode 3 : Stored DTCs.
Mode 4 : Clear/Reset DTCs and emissions-related diagnostic information.
Mode 5 : 02 monitoring tests, supported.
Mode 6: Test results for continuously and non continuously monitored
systems, supported.
Mode 7: Pending DTCs.
Mode 8: Request control of on-board-system, test or component
(bidirectional controls).
Mode 9: Request VIN and other data.
Mode 10:** Allows a scan tool to obtain permanent codes.
Contact Us
For service and support, please contact us.
Website: www.foxwelltech.us
E-mail: support@foxwelltech.com
Service Number: + 86-755-26697229
Fax: + 86-755-26897226
Pictures illustrated here are for reference only and this Quick Start Guide 1s subJect to change without prior notice. For more details, please refer to the User’s Manual.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>