PHILIPS STE3170 2 In 1 Garment Stand Steamer User Manual
- June 12, 2024
- Philips
Table of Contents
PHILIPS STE3170 2 In 1 Garment Stand Steamer
Product Information
The product is a steamer appliance designed for home use.
The appliance is suitable to be used with tap water. However, if you live in
an area with hard water, it is recommended to mix an equal amount of tap water
with distilled or demineralized water.
This will prevent fast scale build-up and prolong the lifetime of the
appliance.
It is important not to use perfumed water, water from the tumble dryer,
vinegar, starch, descaling agents, ironing aids, chemically descaled water, or
other chemicals, as they may cause water spitting, brown staining, or damage
to the appliance.
The appliance has an auto-off mode which activates when the water tank is
empty or when the steam hose is bent. It also switches off automatically after
10 minutes if the water tank is not refilled or the steam hose is not
straightened.
If you encounter any problems with the appliance, you can visit
www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your
country.
Product Usage Instructions
- Ensure that you have read the instruction manual carefully before using the appliance.
- If you live in an area with hard water, mix an equal amount of tap water with distilled or demineralized water before filling the tank.
- Do not use perfumed water, vinegar, starch, descaling agents, or other chemicals in the appliance.
- Make sure the water tank is properly inserted and filled to an appropriate level.
- If the appliance does not produce steam or produces irregular steam, let it heat up for approximately 1 minute.
- If water droplets drip from the steamer head or the appliance produces a croaking sound, lift the steamer head to straighten the hose vertically.
- If an excessive amount of water drips out of the steamer head during heating, lift the steamer head to allow condensation to flow back and refill the water tank.
- If the steam supply hose has been left in a low position for a long time, lift the steamer head to straighten the hose vertically to allow any condensation to flow back.
- If there is low water level in the tank or if the tank is not inserted properly, refill the water tank and insert it properly.
- If too much scale has built up in the appliance, perform the calc-clean process as described in the instruction manual.
- Do not leave dirty water inside the appliance for a long time.
Perform the calc-clean process to clean the appliance.
Please read this instruction carefully before using the appliance.
Please keep this instruction book for future reference.
WHAT’S IN THE BOX
WARNING
SETTING
CLEANING
The appliance is suitable to be used with tap water.
However, if you live in an area with hard water, we recommend that you mix an
equal amount of tap water with distilled or demineralized water.
This will prevent fast scale build up and prolong the lifetime of the
appliance.
Warning: Do not use perfumed water, water from the tumble dryer, vinegar, starch, descaling agents, ironing aids, chemically descaled water or other chemicals, as they may cause water spitting, brown staining or damage to your appliance.
POWER ON OFF
MAINTENANCE
Figure 1-1: The appliance will go into auto-off mode (LED light will
blink) when the water tank is empty or when the steam hose is bent.
Figure 1-3: It switches off automatically after 10 minutes if the water
tank is not refilled or the steam hose is not straightened.
If you have any problems, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Center in your country.
| Problem | Possible cause | Solution |
|---|---|---|
| The appliance produces no steam or irregular steam. | The steamer has not |
heated up sufficiently.
| Let the appliance heat up for approximately 1 minute.
| Steam has condensed in the hose.| Lift the steamer head to straighten the
hose vertically. This allows any condensation to flow back.
| Low water level in the tank or the tank is not inserted properly.| Refill
the water tank and insert
it properly.
| Too much scale has built up in the appliance.| Perform calc-clean process.
Refer to section.
Water droplets drip from the steamer head or the appliance produces a croaking
sound.| The steamer head and/or steam supply hose have been left in low
position for a long time (≥ 5 mins).| Lift the steamer head to straighten the
hose vertically. This allows any condensation to flow back.
| When pole height is brought down, hose follows to be lowered. Steam is
unable to pass through hose smoothly and thus forming condensation in the
hose.| Lift the steamer head to straighten the hose vertically. This allows
any condensation to flow back.
An excessive amount of water drips out of the steamer head when the appliance
is heating up.| The water in the appli- ance is dirty or has been left inside
the appliance for a long time.| Perform calc-clean process.Refer to section.
Water leaks out from the steamer base.| You have not closed the water tank cap
or de- calc knob securely.| Close the water tank cap or de-calc knob securely.
---|---|---
| The water tank is not inserted properly.| Insert the tank properly.
| The steamer head and/ or steam supply hose have been left in low position
for a long time (≥ 5 mins).| Lift steamer head to straighten the hose
vertically. This allows pressure to be released inside the tank.
| Low water level in the tank resulting to pressure build up inside tank|
Remove the water tank and fill it to at least half of the tank.
PHILIPS and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.
This product has been manufactured by and is sold under the responsibility of Versuni Holding B.V., and Versuni Holding B.V. is the warrantor in relation to this product.
2023 © Versuni Holding B.V.
4239.001.2376.2
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>