ROC Commerce SDH-SW04-SS-NR Barn Door Hardware Instruction Manual
- June 12, 2024
- ROC Commerce
Table of Contents
BARN DOOR HARDWARE
THE BROWNSTONE
Hardware kit for sliding single wood door.
304 Grade Stainless Steel
MODEL No. SDH-SW04-SS-NR
INSTALLATION MANUAL
**TOOLS REQUIRED
**
- Plumb Line
- Pencil
- Phillips Head Screwdriver
- 8mm Routing Drill Bit
- 10mm Drill Bit
- 5.5mm Drill Bit
- Level
- Tape Measure
- Power Drill
INCLUDED IN KIT
| A | 78-3/4″ Rail | x1 |
|---|---|---|
| B | Door Roller Hardware | x2 |
| C | End Bracket | x2 |
| D | Center Bracket | x2 |
| E | ST4.8×50 Bolt | x4 |
| F | ST5.5×32 Screw | x4 |
| G | Floor Anchor | x4 |
| H | Non-Routed Floor Guide | x2 |
| I | Door Stop | x2 |
| J | 4mm/6mm Allen Keys | x1 |
NOTES
Minimum door overlap on guide is 1-15/16″
To obtain maximum weight capacity, all fasteners must be mounted into solid
wood studs or wall blocking or mounted to a header board.
Adjustable mounting brackets allow for standard 16″ U.S. stud spacing, or any
variation.
Consult a structural engineer if you have questions about what type of wall
blocking is required.
THE BROWNSTONE
Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
Attach the track to the wall brackets as shown.
- Remove the anti-rise pin from the door roller using the provided 4mm Allen key.
- Drill holes centered in the door thickness for the door roller anchors using an 8mm routing drill bit.
Attach the door to the rail.
Plumb the door and fastem the metal floor guides to the floor using the screws and anchors provided. The opening will depend on the thickness of your door. The guides are adjustable and will accept any thickness.
Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment.
Reattach the anti-rise pin to the door rollers
Architectural Products by Outwater assumes no liability for improper installation.