eufy WetVac W31 Wet and Dry Cordless Vacuum Cleaner User Guide
- June 12, 2024
- Eufy
Table of Contents
QUICK START GUIDE
Quick Tips
Insert the handle bar into the main body
You will hear a click when the handle bar is locked in place.
Remove the clean water tank, open the rubber cover, and add water
Note: Use 2 bottle caps of floor cleaner for best results.
Replace the clean water tank
You will hear a click when the water tank is locked in place.
Prepare to clean
Gently step on the foot pedal and push the handle bar backward until you hear
a click.
Press the Power button to start cleaning
Press the speed control button to select a rotation speed: High / Low.
Press the water spray button. Water and floor cleaner will spray onto the
rolling brush.
Finish cleaning
Press the power button or push the handle bar forward until you hear a click.
The vacuum automatically turns off.
Note: After you press the power button, it will take 5 seconds for the vacuum
to stop cleaning.
Self-cleaning
Place the vacuum on its charging base to charge and press the self-cleaning
button. It will take 3 minutes to finish the self-cleaning. Do not move the
vacuum during self-cleaning.
Cleaning and Maintenance
Remove the dirty water tank after use
Press the release button to remove the dirty water tank.
Clean the dirty water tank
Rinse the dirty water tank thoroughly with water.
Replace the dirty water tank
After cleaning, reinstall and replace the dirty water tank by tilting it
backward at a 45° angle.
Note:
When the “Cleaning” indicator for the dirty water tank lights up red, check if
the filter and dirty water tank are dirty. Wash and air dry them before reuse.
The quick start guide is for routine cleaning. You can find detailed instructions in the user manual.
51005003245 V01