GreenTouch 2014ATH-113 Single Robe Hook Towel Ring Installation Guide
- October 31, 2023
- GreenTouch
Table of Contents
Model# of GreenTouch
2014ATH-113
2014ATH-122
2014ATH-123
2014ATR-113
2014ATR-122
2014ATR-123
2014ATP-113
2014ATP-122
2014ATP-123
I NSTALLATION AND CARE GUIDE
SINGLE ROBE HOOK
TOWEL RING
SINGLE-POST TOILET PAPER HOLDER
Safety Information
Please read and understand this entire manual before attempting to assemble, operate, or install the product.
Pre-Installation
PLANNING INSTALLATION
Before beginning installation of these products, ensure all parts are present.
Compare parts with the Package Contents and Hardware Included lists. If any
part is missing or damaged , do not attempt to install the products.
TOOLS REQUIRED
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size.
| Part | Description | Quantity |
|---|---|---|
| AA | Wood screw | 2 |
| BB | Mounting bracket | 1 |
| CC | Plastic anchor | 2 |
| DD | Set screw | 1 |
PACKAGE CONTENTS
| Part | Description | Quantity |
|---|---|---|
| A | Single robe hook | 1 |
| B | Towel ring | 1 |
| C | Single-post toilet paper holder | 1 |
Installation
-
Marking the mounting location
□ Remove the set screw (DD) from the base of the product post.
□ Place the product in the desired mounting location, using a level to position it accordingly, and use a pencil to lightly mark the outline of the post(s).
□ Center the mounting bracket (BB) within the marked post location(s), and mark where the screw holes will be drilled.
□ Repeat this step as needed for each bath accessory. -
Installing the mounting brackets
□ Drill 1/4 in. holes in the previously marked locations.
□ Push the plastic anchor (CC) flush intu the dry wall or tile
□ Fasten the mounting bracket (BB) to the wall with the wood screws (AA).
□ Repeat this step as needed for each bath accessory.
NOTE:
When mounting the products to a wood wall, fasten the mounting brackets (BB) to the wall using the wood screws (AA). There will be no need for drilling or plastic anchors (CC). -
Installing the product
□ Place the post over the mounting bracket (BB) and secure it with the set screw (DD), as shown.
□ Repeat this step for the remaining bath accessories.
Care and Cleaning
□ Preserve the finish of the bath accessories using a non-abrasive wax.
□ When using non-abrasive cleaners, rinse off immediately when finished
cleaning the bath accessories.
□ Do not use abrasive cleaners when cleaning these bath accessories.
Service Parts
For replacement parts, call our customer service department at 704-461-3893, 9
a.m. – 5 p.m., EST, Monday – Friday.
You could also contact us at
support@edbyellenbath.com.
| Part | Description | Quantity |
|---|---|---|
| 1 | Mounting hardware (screw, bracket, and plastic anchor) | RP80061 |
| 2 | Set screw | RP50078 |