Lindby GU10 Outdoor Wall Lamp Instruction Manual
- June 12, 2024
- Lindby
Table of Contents
Lindby GU10 Outdoor Wall Lamp Instruction Manual
Installation instructions
Before using for the first time / Liability notice
Dear Customer, Unpack the product carefully and check that it is complete and
intact. The light should not be used if there is any damage to the cable,
glass or electrical parts. In such a case, contact the service address named
below immediately. Read through these instructions carefully. This will help
you to avoid errors, which could lead to a hazard or malfunction. Keep the
instructions in case you have any questions later. Pass on the instructions to
each subsequent owner or user of the product. Ensure that any supplement to
the instructions is enclosed. The manufacturer cannot be made responsible
and/or liable for personal injuries or damage to property caused by:
- incorrect installation
- changes made to the product
- improper use (misuse)
- failure to observe these instructions
Health and safety regulations
Comply with the national installation and safety regulations for the
installation, operation and maintenance. Always note the symbols on the
packaging and in these installation instructions. Refer to the following list
for the precise meanings of the symbols:
Notes on the installation sketch
Intended use / foreseeable misuse
This product is used for lighting. Further information on the intended use is
given on the installation sketch p. 9. Do not expose the light to large
mechanical loads or stresses or heavy soiling. For safety reasons, you should
not change and/or modify the product. Any use other than that described above
can damage the product. This can cause hazards such as a short-circuit,
electric shock or fire.
Cleaning / maintenance
The light should always be cooled and disconnected from the power supply
before cleaning/ maintenance work is carried out! Check that no voltage is
present. For regular cleaning, use a dry or lightly moistened cloth and never
use chemicals or abrasive cleaner/scouring agent.
Notes on disposal
This light should not be disposed of in the normal household waste. It should
be handed in to a collection point for the recycling of large electrical and
electronic appliances. Please find out about the relevant provisions regarding
the separate collection of waste electrical and electronic equipment (WEEE) in
your country. Correct disposal of your waste equipment protects the
environment and people against potential negative consequences.
Batteries do not belong in household waste! Used batteries must be handed in
to the public collection points in your municipality or wherever batteries are
sold.
Declaration of conformity and service address
The light is designed, produced and tested in conformity with EN 60598 and
fulfils the fundamental safety requirements of the EU Directives 2014/35/EU
and 2014/30/EU. The complete declaration of conformity is available at the
service address named in the following: LUQOM Holding GmbH, Seelbüde 13,
D-36110 Schlitz ‘ 020 3514 3658 * info@luqom.eu
Subject to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>