ARGON AUDIO IE20 In Ear Earphones User Guide
- June 12, 2024
- ARGON AUDIO
Table of Contents
IE20 Quick start
Charging instruction
Please fully charge the case and ear buds before first time use. The different numbers of LEDs on the bottom of the charging case flashing will show the different charge level of the case; see the chart below for details. When the charging case is fully charged, all four lights turn on.
| Power | LED light |
|---|---|
| <25% | The first light is flashing |
| 25-50% | The first light is on, and the second light is blinking |
| 50-75% | The first two light is on, and the third light is blinking |
| 75-99% | The first three lights are on, the 4th light is blinking |
| 100% | All four lights are on |
Power on/pairing mode
Open the charging case while the earbuds are still in the case to initiate
pairing mode. Enter Bluetooth settings on your device and select Argon Audio
IE20 to start pairing. If the pairing was successful; you will hear the
“connected” voice prompt in the ear buds.
To enter pairing mode manually, place both left and right earbuds into the
charging case, keeping the case cover open. Press and hold the charging case
button for 5 seconds. The four LEDs will flash alternately in pairs before
emitting constant light for 3 Seconds. This indicates that the earphones have
entered Bluetooth searching and pairing mode. If there is no connection in
pairing mode for 5 minutes, the earbuds will automatically power off. 
Music and phone controls
| Play/Pause/Reject/End calls | Press the L/R ear bud button 2 times |
|---|---|
| Answer a call | Press the L/R ear bud button once |
| Volume up | Press the Right ear bud button once |
| Volume down | Press the Left ear bud button once |
| Previous song | Press and hold the Left ear bud button for 1.5 seconds |
| Next song | Press and hold the Right ear bud button for 1.5 seconds |
| Voice assistant | Press the L/R ear bud button 3 times |
| Power off | Put L/R earbuds into the case, close the charging case |
| ANC on/ambient mode/default mode | Press and hold R/L button 2 seconds to |
switch the Modes
Restore factory settings
Remove the earphone device listing from the Bluetooth settings on your phone.
Place the earphones into the charging case.
Press and hold the charging case button for 10 seconds with the case cover
open. The 4 light indicators on the charging case will start flashing, before
emitting constant light for 3 seconds.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>