ANKER PowerCore 26800mAh Power Bank User Guide
- June 12, 2024
- Anker
Table of Contents
Welcome Guide
Power Core 26800
Power Bank
User Guide
Using Your Power Core
-
Check the power level
No preserve battery lifespan, use and recharge at east once every & months. -
Charge your phone or tablet
No
Lighting cable included -
Recharge your Power Core
This Power Core has dual input ports, Using a multiport charger with two Micro US8 cables will provide a significantly fuser charge.
When your Power Core is fully charged, the LED indicators will torn off
To give your Power Core the fastest, safest recharge, use an Anker? USB
charger.
Important Safety Instructions
When using this product, basic precautions should always be followed, including the following:
- Store product in a cool and dry place.
- Donot store the product in hot or humid environments.
- Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons,
- Operating temperature should be between 32°F / O°C to 95°F / 35°C,
- Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
- If the product is not used for long periods of time, you should change and discharge once every three months.
- When charging a device, the product may feel warm, this is a normal operating condition and should not be cause for concern,
- Informal conditions, the battery performance will decline over several years,
- Do not dispose of the product in heat or fire.
- Do not clean the product with harmful chemicals or detergents.
- Misuse, dropping, or excessive force may cause product damage.
- When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other,
- Be aware discharged battery may cause fire or smoke, tape the terminals to insulate them.
Notice
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1277 is
in compliance with Directives 2001/95/EC, 2014/30/EU & 2011/65/EU.
The full text of the EU declaration of conformity is available at the
following internet address: www.anker.com
Anker Innovations Deutschland GmbH | Georg-Much-Strasse 3, 80807 Munich,
Germany
Anker Technology (UK) Limited | GNR8, 49 Clarendon Road, Watford,
Hertfordshire, WD17 1HP, United Kingdom
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Songkok, Kowloon, Hong Kong
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1277 is
in compliance with following Directives: Electromagnetic Compatibility
Regulations 2016, The Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic
Equipment Regulations 2012. The full text of the UK declaration of conformity
is available at the following internet address: https://www.anker.com
Anker Technology (UK) Limited | GNR8, 49 Clarendon Road, Watford,
Hertfordshire, WD17 1HP, United Kingdom
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party:
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: 1-800-988-7973
IC Statement
This device complies with Industry Canada license-ICES-003.
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Specifications
| Cell Capacity | 26800 mAh / 96.48 Wh |
|---|---|
| Input | 5 V— 4 A (5 V— 2 A Max Per Port) |
| Output | 5 V— 6 A (5 V— 3 A Max Per Port) |
| Size | 180 x 81.5 x 22 mm/7 x 3.2 x 0.9 in |
| Weight | 495 g /1/5 oz |
Attention
| Use original or certified cables
---|---
| Do not expose to liquids
| Do not disassemble
| Avoid dropping
| Avoid extreme temperatures
Customer Service
18-month limited warranty
Lifetime technical support
support@anker.com
(US/CA) +1 (800) 988 7973
(UK) +44 (0) 1604 936200
PAP 22
Raccolta Carta
For FAQs and more information, please visit:
@Anker
@Anker Japan
@Anker Deutschland
@AnkerOfficial
@Anker_JP
@Anker
Product Number A1277
External Battery / Portable Charger
51005001989 VO0O5
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>